Magtek DynaPro Go Quick installation manual

Page of 4

Download

Bookmark us

DynaPro Go

Handheld PIN Pad Device with

MSR/Contact/Contactless

Quick Installation Guide

Installing DynaPro Go is straightforward: Configuration is done prior to deployment for the

certificate authority public keys and terminal and payment brand settings; end users need only set

up a host with appropriate software, configure the software, and connect the device to the host.

DynaPro Go

Compatible Operating Systems

iOS 7.1 and later

Android 4.4.2 and later

Windows 7, Windows 8.1, Windows 10

Page 1
Dynapro go handheld pin pad device with msr/contact/contactless quick installation guide installing dynapro go is straightforward: configuration is done prior to deployment for the certificate authority public keys and terminal and payment brand settings; end users need only set up a host with appro...
Page 2
Contents/pre-installation checklist figure 1. Major components diagram the major components of dynapro go are shown in figure 1. In addition to the components shown, the device has a tam- per trigger recessed in the bottom that is intended for manufacturer use only. Do not insert anything into the t...
Page 3
To connect dynapro go to a host computer or charger using the micro usb port, follow these steps: • connect the small end of the usb cable to dynapro go as shown in figure 3. • connect the large end of the usb cable to the charger or to the host computer’s usb port. As soon as dynapro go starts rece...
Page 4
Compliance fcc information this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operatio...