Maha Energy MH-C800S Instruction Manual - page 2
PRINTED IN TAIWAN A03-3713377-451
2. Insert AA and/or AAA batteries.
NOTE: Ensure that the batteries are pressed down all the way to
ensure optimal contact.
3.
When the battery is correctly inserted, charging will commence for that
slot.
My battery cannot be detected, what should I do?
First, make sure the battery is properly seated. Insert the battery so
that the negative end touches the charging contacts first, then tilt it
forward until it clicks. You can also try removing the battery and
inserting it into another slot. If the battery still cannot be recognized, it
might no longer accept a charge and should be replaced.
It is normal of the charger to make a faint clicking sound, which is
a result of the pulse charging.
When the charging is nearly complete, the batteries will become
hot to the touch. Battery temperature will quickly drop after charging
is finished.
The charger is equipped with a four-level battery gauge which displays
the charging progress.
Flashing
Flashing
Flashing
Solid or
Flashing
0-50%
charge
50-80%
charge
80-100%
charge
Charging
completed.
Flashing
Extremely low charge.
Typically indicates abnormal or
aged batteries. Conditioning is
recommended.
Flashing all together
Battery fault
Soft Charging Mode
NOTE: Soft Charging is activated for all battery slots simultaneously and
cannot be activated for each individual battery.
1. Remove all batteries from the charger, if any.
2. Insert
one battery in the any slot.
3. Within five seconds, press and hold the “SOFT” button until “Soft
Charging” symbol is displayed on the LCD screen.
4. Insert the remaining batteries.
5.
Soft Charging mode will remain activated as long as there are batteries
in the charger (even if charging is completed). The charger will reset to
Rapid Charge mode (Soft Charging symbols disappears) when all
batteries are removed.
Conditioning Mode
NOTE: Conditioning is activated for all battery slots simultaneously and
cannot be activated for each individual battery.
1. Remove all batteries from the charger, if any.
2. Insert
one battery in any slot.
3. Within five seconds, press and hold the “CONDITION” button until
”Condition” symbol is displayed on the LCD screen.
4. Insert the remaining batteries.
5.
The condition cycle will first apply an initial charge, discharge then
recharge the batteries.
Initial Charging
Discharging
Standby for
Recharging OR
Recharging
Finished
It is normal for all symbols to disappear from one or more slots toward
the end of discharge. This indicates that discharging is nearly
completed and recharging will commence soon.
During discharging, batteries that finish before others will show
“CHARGE” symbols. However, actual charging will not commence until
all batteries have finished discharging.
It is also normal for the left side of the charger to become warmer
during the conditioning cycle.
Manufactured By:
MAHA ENERGY CORP.
1647 Yeager Ave. La Verne, CA 91750
Tel: 1-800-376-9992, 1-909-392-1568
http://www.mahaenergy.com/
Copyrighted ® 1998-2007 Maha Energy Corp.