Mahlkönig Tanzania Operating Instructions Manual - page 18
|
L A D E N M Ü H L E N
S H O P G R I N D E R
9.2 Replacing components
9.2.1 Replacing the grinding discs
When the grinding quality is no longer as desired, this means that the
grinding discs need to be re-placed.
The grinding discs must not be removed until the
machine is completely at rest! Before beginning this
task, switch off the machine and pull out the mains
plug from the mains socket.
Procedure:
1. Remove the stationary disc fl ange
(1) according to the description
in the section 9.1.2 “Cleaning the
grinding mechanism” (steps 1-5).
2. Remove the grinding disc (2) from
the stationary disc fl ange (1), and
the grinding disc (3) from the rotat-
ing disc fl ange (4). The respective
procedure is described in the next
two sections.
3. Insert the new grinding discs.
HINT
Ensure that the mating surfaces are absolutely clean before reassembly!
Failure to do so will result in inconsistent grinds.
1
4
2
3
9.2.1.1 Removing the grinding disc in the rotating fl ange,
without screws
Procedure:
1. Place a screwdriver (size 3) in the groove (1) at the grinding disc (2).
2. Rest the tip of the screwdriver on the facing edge and use it to lever
the grinding disc.
3. Once the grinding disc has overcome the magnetic attraction, it can
be removed manually.
Installation of the grinding disc is carried out in reverse order.
HINT
Ensure that the grinding discs are positioned correctly during installa-
tion. Observe the position of the driver!
HINT
Ensure that all the mating surfaces
are absolutely clean before reas-
sembly! Failure to do so will result
in inconsistent grinds.