Majestic 400BWBA Installation and operating istructions - page 4
4
61D0008
OPERATION GUIDELINES
HOW YOUR FIREPLACE SHOULD BE USED
This fireplace is intended for supplemental heating only and
is not intended for use as a primary heating system.
This fireplace is designed to sit directly on a combustible floor.
The fireplace must be installed with clearances to combustible
building materials as specified by this manual. Only parts
manufactured by MHSC and labeled for use with this fireplace
should be used in the installation of the fireplace except for
special roof flashings that may be fabricated locally. The use
of improper parts in the installation can be hazardous and
voids the warranty offered by MHSC.
This fireplace is designed to burn solid wood fuel (wood),
UL- classified processed solid fuel fire logs, or a certified
decorative gas appliance may be installed in the fireplace as
described later by this instruction manual.
This fireplace is not designed to burn coal, unplumbed liquid
fuels, unplumbed gaseous fuels or household refuse. Any
attempt to burn these fuels in the fireplace can be hazard-
ous.
HOW YOUR FIREPLACE WORKS
As wood is burned in the fireplace, room air entering the
fireplace is circulated around the fireplace firebox. This air
circulation protects the firebox from overheating. Air circula-
tion through the fireplace must not be blocked or restricted
in any manner. Blocking or restricting air circulation through
the fireplace can cause a fire hazard.
RESIDENTIAL INSTALLATION
In residential type installation, an AK4 outside combustion air
kit may be connected to the left side of the fireplace to allow
outside air to enter the firebox through a dampered opening in
that side of the fireplace. This
outside combustion air
feature
reduces the room air used for combustion and prevents exces-
sive heat loss from the room. When the fireplace is in use,
the fireplace’s “outside combustion air” damper connected
to an AK4 may be opened to allow air from outside to enter
the fireplace firebox. When the fireplace is not in use, the
“outside combustion air” damper should be closed to prevent
cold air from entering the firebox. An “outside combustion
air” damper is open when its control lever is up and closed
when its control lever is down. A control lever for the
outside
combustion air
damper is located inside the firebox near the top
of the side firebrick on the left side of the fireplace. The design
of the fireplace allows the routing of the combustion air duct
downward or horizontally to obtain the outside combustion
air; this permits flexibility in planning your installation. See
Figures 24 thru 27 and their instructions for typical installa-
tion of outside combustion air kits. Review the precautions
and recommendations in this manual pertaining to outside
combustion air.
Note: Outside air for combustion is optional in
residential type installations unless required
by local codes. Outside air for combustion
it is mandatory in manufactured home
installations. Use an AK6 outside combustion
air kit in manufactured home installations,
instead of the AK4 offered for residential type
installations.
GLASS DOORS
Glass doors (models GD36BA, GD36PBA, GD36SSA,
GD42BA, GD42PBA and GD42SSA by MHSC) may be
installed to receive the maximum benefit from your fire-
place. For large fires, the maximum heating benefit from
the fireplace will be obtained with the doors open due to the
high amount of radiant heat being emitted out of the front
opening of the fireplace. With a small fire, or before retiring
in the evenings, it is best to operate the fireplace with the
doors closed to prevent excessive room air from being drawn
up the chimney. When the doors are open, the mesh screens
should be closed to help keep burning embers from popping
out of the firebox.
Note: Glass doors are mandatory on fireplaces
installed in manufactured homes.
Fireplaces equipped with glass doors
should be operated only with the
glass doors fully open or fully closed.
If doors are left partly open, gas and
flame may be drawn out of the fireplace
opening, creating risks of both fire and
smoke.
W
ARNING