Majestic concert marimba Assembly Instructions Manual

Summary of concert marimba

  • Page 1

    Mallet instrument assembly instructions concert marimba — 4 octave model concert xylophone — 4 & 3-1/2 octave model concert vibraphone — 3 octave model 產品組立說明書: 室內型立奏低音木琴 — 4 個八度音型號 室內型立奏高音木琴 — 4 & 3-1/2 個八度音型號 室內型立奏顫音鋁琴 — 3 個八度音型號.

  • Page 2: Materials

    P2 check contents carefully. Each model should include following: 每一組琴應該要包括下列組件,請仔細檢查內容: materials 零件 1 2 3 4 5 6 7 8 9 item parts description 零件敘述 qty 數量 1 leg assembly with 4" casters 木琴側架含 4" 腳輪 2 units 2 cross bar 方型連結桿 1 pc 3 curved brace 圓弧形支撐架 2 pc 4 pedal assembly (vibraphone only) 踏板組件(顫音鋁琴...

  • Page 3

    P3 frame set up & resonator attachment 琴架、琴框、共鳴管組裝 1 2 connect curved braces to cross bar with hand knob. Do not tighten. 將圓弧形支撐架與方形連結桿以旋鈕結合, 但請勿鎖緊。 identify low end leg assembly. With leg assemblies lying flat with the height adjustment crank handle on the floor and the crossbar receivers facing up, ...

  • Page 4

    P4 secure keyboard frame to top of leg assemblies with hand knob. Low (wide) end of keyboard frame should be over leg identified as low end in step 2. 將固定式琴框置於琴架上方,並將固定旋鈕鎖緊。 (vibraphone only) to attach vibraphone pedal pull rods, first, loosen the square head bolt of universal head joint by tuning key...

  • Page 5

    P5 besides the preset pedal weight, user can switch to the other connecting position for heavier pedal response. 踏板反應力度除原廠預設外,使用者需可依其所好,將拉桿連接是前一 個孔位,使用較重的踩踏反應。 5 6 resonators are inserted from below. Insert higher register side first (narrow end), then swing lower register side (wide end) into rubbbe...

  • Page 6

    P6 (vibraphone only) align rotors of two resonator banks; then loop motor belt around fan pulley at naturals side, and under security plate. 先將共鳴管活葉調整於相同開闔位置,再將馬達皮帶繞於全音共鳴管活頁皮 帶輪上,並置於固定板下方。 hold the rotor shaft at naturals side, then turn the shaft of accidentals side, until motor belt fit in the pull...

  • Page 7: Tone Bar Mounting

    P7 beginning with naturals (or c diatonic keyboard), lay tone bars carefully on frame. Hook string at high (narrow) end of instrument around end bar posts and begin positioning bars between adjacent bar posts, working progressively down keyboard towards lowest (largest) bars. Once all bars are place...

  • Page 8

    Mallet instrument ver.201205 www.Majestic-percussion.Com.