1. DL manuals
  2. Majestic Fireplaces
  3. Indoor Fireplace
  4. Sovereign SC36A
  5. Homeowner's Installation And Operating Manual

Majestic Fireplaces Sovereign SC36A Homeowner's Installation And Operating Manual

Other manuals for Sovereign SC36A: Brochure & Specs
Manual is about: SR/SC Series "A" Woodburning Fireplace

Summary of Sovereign SC36A

  • Page 1

    12345678901234567890123456789012123456 12345678901234567890123456789012123456 12345678901234567890123456789012123456 12345678901234567890123456789012123456 12345678901234567890123456789012123456 12345678901234567890123456789012123456 12345678901234567890123456789012123456 123456789012345678901234567...

  • Page 2: Safety Information

    2 sr/sc series "a" woodburning fireplace 7412948 safety information please read this manual before installing and using fireplace. Important: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will ...

  • Page 3

    3 sr/sc series "a" woodburning fireplace 7412948 fp590 fig. 2 sc36a series specifications and framing. Sc36a series woodburning fireplace — circulating model ⁵⁄₈ " (16mm) ¹⁄₂ " (13mm) ¹⁄₂ " 36" (914mm) 38 ¹⁄₄ " (971mm) 40" (1016mm) ⁵⁄₈ " (16mm) 22³⁄₄ " (578mm) 1³⁄₄ " (45mm) 35¹⁄₂ " (902mm) 24" (610m...

  • Page 4

    4 sr/sc series "a" woodburning fireplace 7412948 ⁵⁄₈ " (16mm) ¹⁄₂ " (13mm) ¹⁄₂ " 42" (1067mm) 38 ¹⁄₄ " (971mm) 46" (1168mm) ⁵⁄₈ " (16mm) 22³⁄₄ " (578mm) 1³⁄₄ " (45mm) 38 " (965mm) 24" (610mm) 7³⁄₄ " (197mm) 7¹⁄₂ " (191mm) recessed nailing flange 11" dia. (279mm) rough opening width 47" rough opening...

  • Page 5

    5 sr/sc series "a" woodburning fireplace 7412948 chase installation insulation methods shown are optional for cold climate, not a requirement for unit operation. Fp554 fig. 5 fireplace and chase parts identification. Termination cap storm collar pan flashing draftstop batt insulation (cut out around...

  • Page 6

    6 sr/sc series "a" woodburning fireplace 7412948 chimney requirements - offset installations 0 0 0 0 0 3" 11" 1 0 0 0 0 8 ¹⁄₄ " 20" 0 1 0 0 0 11 ¹⁄₄ " 25 ¹⁄₄ " 2 0 0 0 0 13 ¹⁄₂ " 29 ¹⁄₄ " 1 1 0 0 0 16 ¹⁄₂ " 34 ¹⁄₄ " 0 0 1 0 0 20 ¹⁄₄ " 40 ³⁄₄ " 2 1 0 0 0 21 ³⁄₄ " 43 ¹⁄₂ " 0 0 0 1 0 26 ¹⁄₄ " 51 ¹⁄₄ " ...

  • Page 7: Planning Information

    7 sr/sc series "a" woodburning fireplace 7412948 planning information preplanning an installation is very important to ensure safety and to save time and money. An installer must predetermine where a fireplace will be set and how the chimney system will be run. Mounting the fireplace a fireplace may...

  • Page 8: Installation

    8 sr/sc series "a" woodburning fireplace 7412948 insulating fireplace enclosure for cold climates if you live in a cold climate, it is not required but highly recommended that you insulate fire- place enclosure to eliminate cold air penetration as much as possible. Insulate base of fireplace with a ...

  • Page 9

    9 sr/sc series "a" woodburning fireplace 7412948 framing framing can be constructed before or after the fire- place is set in place, however, most installers build the frame before setting the fireplace. Frame fireplace with 2 x 4 lumber or heavier materials. Refer to framing dimensions in figures 1...

  • Page 10

    10 sr/sc series "a" woodburning fireplace 7412948 straight-up chimney installation to mark the centerline of the flue, put the fireplace in final position and measure out from the wall: 9 ¹⁄₄ " (235mm). Mark a spot on the ceiling directly above the fireplace. Draw a line parallel to the back wall th...

  • Page 11

    11 sr/sc series "a" woodburning fireplace 7412948 note: safety strips are not required over noncom- bustible floors where all supports at the base of the fireplace are noncombustible. Four (4) nailing flanges are incorporated on each corner of the surround. Bend the nailing flanges out, level the bo...

  • Page 12

    12 sr/sc series "a" woodburning fireplace 7412948 continue installing the pipe as required until pipe is installed up through the ceiling. At this point, you must install a firestop spacer. Installing the firestop spacer in the ceiling hole a firestop spacer is used to keep pipe spaced properly and ...

  • Page 13

    13 sr/sc series "a" woodburning fireplace 7412948 install the attic insulation shield with the flanges on its base extending down into the framing hole. Nail each corner of attic insulation shield to the framing members of the ceiling hole using 8d nails. Attic shields are not required at the roof. ...

  • Page 14

    14 sr/sc series "a" woodburning fireplace 7412948 installing top housing or termination follow the installation instructions provided with the chimney termination you have selected. Installing chimney in a chase refer to page 5, figure 5 for an illustration of a typical chase installation. Caution: ...

  • Page 15

    15 sr/sc series "a" woodburning fireplace 7412948 ma81 fig. 22 combustible mantle clearances. 1 ¹⁄₂ " ref. Combustible materials are permitted within a shaded area shown in figure 23 titled minimum wall clearances. * ** *12" from top of fireplace opening for radiant models 12" from top of grille ope...

  • Page 16

    16 sr/sc series "a" woodburning fireplace 7412948 hearth installation a hearth extension is required to protect a combustible floor in front of the fireplace. Refer to figure 23 for minimum dimensions and mounting detail. Note: hearth extension must not cover the air inlet opening of a fireplace. Th...

  • Page 17

    17 sr/sc series "a" woodburning fireplace 7412948 common materials and factors material k* r minimum thickness eh2416 common brick 0.458 5.0 1.09 0.50 in.** 0.10 5.46 in.** (cfm corporation) r value is for ¹⁄₂ inch. * units of k = btu/sq ft/hr/ßf/in ** thickness of listed material fp533add warning: ...

  • Page 18

    18 sr/sc series "a" woodburning fireplace 7412948 installing line for gas logs cfm specialty home products fireplaces are designed to accept a 1/2" (13mm) gas line for installation of an approved gas appliance. (cfm specialty home products manufactures a wide variety of gas logs for use in cfm speci...

  • Page 19: Sr36A/42A, Sc36A/42A Series

    19 sr/sc series "a" woodburning fireplace 7412948 cfm specialty home products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. 948 1 2 3 4 5 6 a b c 7 8 9 10 11 12 d 14 13 e sr36a/42a, sc36a/42a series it...

  • Page 20: Accessories

    20 sr/sc series "a" woodburning fireplace 7412948 the following accessories for this appliance are available from your local majestic fireplaces distributor. Should you need additional information beyond what your distributor can furnish, contact: cfm specialty home products, 410 admiral blvd., miss...

  • Page 21: Chimney Components

    21 sr/sc series "a" woodburning fireplace 7412948 chimney components round top termination top used to terminate chimney at roof. Rltsk8 (flashing not included.) round top termination - top used to terminate chimney at chase. Rltsk8l extended (flashing not included.) flashing metal finishing require...

  • Page 22

    22 sr/sc series "a" woodburning fireplace 7412948 chimney collar enclosure installs on the "over the chimney collar" of the cce-sk fireplace; provides outside air to assist in cooling the chimney system. Attic insulation shield used to prevent insulation from coming in ais-sk contact with the chimne...

  • Page 23

    23 sr/sc series "a" woodburning fireplace 7412948 ™ limited warranty & 30 year protection plan for majestic fireplaces ® pre-engineered fireplace systems cfm specialty home products warrants its majestic fireplaces® pre-engineered fireplace (“fireplace”) and the cfm specialty home products supplied ...

  • Page 24

    410 admiral blvd. • mississauga, ontario, canada l5t 2n6 • 905-670-7777 www.Majesticproducts.Com • www.Vermontcastings.Com cfm specialty home products.