1. DL manuals
  2. Majestic Fireplaces
  3. Outdoor Fireplace
  4. SuperHearth SHR48
  5. Homeowner's Installation And Operating Manual

Majestic Fireplaces SuperHearth SHR48 Homeowner's Installation And Operating Manual

Other manuals for SuperHearth SHR48: Brochure & Specs, Homeowner's Installation & Operating Manual

Summary of SuperHearth SHR48

  • Page 1

    1384 shr cover 5/27/99 djt shr series woodburning fireplace for models: shr36 shr42a shr48 shr52 underwriter's laboratories report no. Mh6018 do not discard this manual: retain for future use. 20001384 4/07 rev. 19 homeowner's installation and operating manual.

  • Page 2: Safety Information

    2 shr series woodburning fireplace 20001384 safety information please read this manual before installing and using fireplace. Important: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void t...

  • Page 3

    3 shr series woodburning fireplaces 20001384 rough opening height 42" (1067mm) 52 " (1327mm) 48 " (1222mm) " " 28 " (724mm) " (189mm) 13 " dia. (340mm) rough opening width 53 " rough opening depth 65 " (1654mm) 65 " (1654mm) " (2340mm) " (267mm)...

  • Page 4

    4 shr series woodburning fireplace 20001384 " (724mm) 7 " (197mm) 48" (1219mm) 58 " (1480mm) 48 " (1232mm) " " " (189mm) 13 " dia. (340mm) rough opening width 59 " rough opening height rough opening depth 66 " (1686mm) 66 " (1686mm) " (2384mm) ...

  • Page 5

    5 shr series woodburning fireplaces 20001384 fp554a sh series 1/28/99 djt chase installation insulation methods shown are optional for cold climate, not a requirement for unit operation. Fp554a fig. 5 fireplace and chase parts identification. (shr48 shown) termination cap storm collar pan flashing ba...

  • Page 6

    6 shr series woodburning fireplace 20001384 chimney requirements - offset installations 0 0 0 0 0 3" 11" 1 0 0 0 0 8 ¹⁄₄ " 20" 0 1 0 0 0 11 ¹⁄₄ " 25 ¹⁄₄ " 2 0 0 0 0 13 ¹⁄₂ " 29 ¹⁄₄ " 1 1 0 0 0 16 ¹⁄₂ " 34 ¹⁄₄ " 0 0 1 0 0 20 ¹⁄₄ " 40 ³⁄₄ " 2 1 0 0 0 21 ³⁄₄ " 43 ¹⁄₂ " 0 0 0 1 0 26 ¹⁄₄ " 51 ¹⁄₄ " 0 1 1...

  • Page 7: Planning Information

    7 shr series woodburning fireplaces 20001384 planning information the ten foot rule major u.S. Building codes specify a minimum chimney height above the roof top. The “ten foot rule” is a fire safety rule and not a draft rule. To ensure proper draft, it is recommended that you always meet or exceed t...

  • Page 8: Installation

    8 shr series woodburning fireplace 20001384 installation chimney supports the chimney system is supported by the fireplace for vertical chimney heights less than 30 feet above the hearth. Chimney supports are required if the vertical height exceeds 30 feet with 11cf chimneys. Locate chimney supports ...

  • Page 9

    9 shr series woodburning fireplaces 20001384 framing framing can be constructed before or after the fireplace is set in place, however, most installers build the frame before setting the fireplace. Frame fireplace with 2 x 4 lumber or heavier materials. Refer to framing dimensions in figures 1 - 4 for ...

  • Page 10

    10 shr series woodburning fireplace 20001384 fp556shr fig. 13 locate centerline of chimney with plumb line. Fp556shr shr locate center line 5/11/99 djt chimney centerline actual centerpoint plumb line plumb bob imaginary centerpoint 11 ¹⁄₈ " (283 mm) fp 548b shr 5/11/99 djt angle of chimney at ceili...

  • Page 11

    11 shr series woodburning fireplaces 20001384 the inside dimension of the frame must be the same as the hole size selected from figure 11 in order to provide the required 2 inches of air space between the outside diameter of the chimney and the edges of the framed ceiling hole. Positioning, safety s...

  • Page 12

    12 shr series woodburning fireplace 20001384 installing the chimney system start by attaching the first chimney section to the collar on top of the fireplace. Install the pipe as pictured in figure 19. When you get a good lock, you will hear the pipe clearly snap together. Once sections are snap-locke...

  • Page 13

    13 shr series woodburning fireplaces 20001384 attic installation ceiling installation fig. 21 installing firestop spacer. Fp285 iwf285 mbuf 5/25/96 nails (4) firestop spacer joist joist firestop spacer nails (4) flange down into hole flange up into hole note: if the attic insulation shield is used, t...

  • Page 14

    14 shr series woodburning fireplace 20001384 cut and frame roof hole size of roof hole varies with the type of chimney termi- nation installed. Refer to installation instructions pro- vided with the chimney termination to find correct size roof hole. There must be a 2" (51 mm) air space between out- ...

  • Page 15

    15 shr series woodburning fireplaces 20001384 fp1166 surround flush with finished wall 12/20/01 djt stud 2 x 4 header ledge bracket surround must be sealed with noncombustible material noncombus- tible decorative facing finished wall fp1166 fig. 26 fireplace surround flush with finished wall. Fp1277 s...

  • Page 16

    16 shr series woodburning fireplace 20001384 fp1167 facing flush with finished wall 12/20/01 djt finished wall stud noncombustible decorative fac- ing must be sealed with noncombustible material surround 2 x 4 finished header covered wall ledge bracket fp1167 fig. 27 facing on fireplace surround flush...

  • Page 17

    17 shr series woodburning fireplaces 20001384 side wall protection adjacent combustible side walls that are within dimen- sions shown in figure 30 of fireplace opening must be protected with wall shield model sp40 or a specifically built wall shield described in figure 29. The special wall shield desi...

  • Page 18

    18 shr series woodburning fireplace 20001384 fp532shr fig. 32 combustible side wall protection and hearth extension dimensions. Minimum wall clearances with noncombustible surround facing without noncombustible surround facing minimum hearth extension dimensions (for on-site construction) g h g j se...

  • Page 19

    19 shr series woodburning fireplaces 20001384 removed from gas line tube to repack space around the pipe. Material should be inserted from outside of the fireplace and packed tightly to totally seal between the pipe and tube. Note: gas pipe should not come in contact with any wood structures until it...

  • Page 20

    20 shr series woodburning fireplace 20001384 1384 pts replacement parts 5/27/99 djt 7/14/99 removed clips,added push nut 1 2 3 4 5 6 7 8 a b c 9 10 11 d 12 13 cfm corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any tim...

  • Page 21: Accessories

    21 shr series woodburning fireplaces 20001384 description designed to enclose the fireplace opening with glass doors allowing the fire to remain visible. Available in polished, brushed brass, black and pewter provides outside air for fuel conbustion in the firebox. This accessory must be installed befo...

  • Page 22

    22 shr series woodburning fireplace 20001384 accessory description model no. Contemporary flashing contemporary chase top termina- tion contemporary round top termina- tion extended round top chimney sections chimney elbows top housing with upper baffle attic insulation shield required for contempora...

  • Page 23

    23 shr series woodburning fireplaces 20001384 limited warranty & 30 year protection plan for majestic fireplaces ® pre-engineered fireplace systems cfm corporation warrants its majestic fireplaces® pre- engineered fireplace (“fireplace”) and the cfm corporation supplied firegrate, glass doors, outsid...

  • Page 24

    © cfm corporation 410 admiral blvd. • mississauga, ontario, canada l5t 2n6 800-668-5323 • www.Cfmcorp.Com cfm corporation.