Majestic NVC36 Installation And Homeowners Operating Instructions - Operating Instructions

10

NVC Series B-Vent 

20000194

Operating Instructions

Only glass approved by CFM Corporation 

should be used on this fireplace.

• 

The use of any non-approved replacement glass will 

void all product warranties.

• 

Care must be taken to avoid breakage of the glass.

• 

Do not operate appliance with glass front 

removed, cracked or broken.

• 

Replacement glass (complete with gasket) is 

available through your CFM Corporation dealer 

and should only be installed by a licensed 

qualified service person.

Glass Information

Louvre Removal

To remove the lou-

vre top assembly, 

lift louvre up and 

then out. (Fig. 12) 

The louvre bottom 

assembly  is hinged 

at the bottom edge 

and swings down.

Lower 

Clamps

FP1191

Window 

Frame As-

sembly

Pull Clamp 

Hook

Push 

Clamp 

Handle

Fig. 11  Window frame assembly removal.

Window Frame 

Assembly

Glass Cleaning

It is necessary to clean the glass periodically. Dur-

ing start-up, condensation, which is normal, forms on 

the inside of the glass and causes lint, dust and other 

airborne particles to cling to the glass surface. Also 

initial paint curing may deposit a slight film on the glass. 

It is therefore recommended the glass be cleaned two 

or three times with a non-ammonia household cleaner 

and warm water (gas fireplace glass cleaner is recom-

mended). After initial use glass should be cleaned two 

or three times during heating season.

Clean glass after first two weeks of opera-

tion.

Do not clean glass when hot.

Do not use abrasive cleaners.

Do not strike or slam the glass.

Log Installation

1

.  Remove window frame assembly. (Refer to Page xx)

2.  Remove logs from the packaging. 

As with all plastic, these bags are not toys 

and should always be kept away from chil-

dren and infants.

3.  Place rear log on back bracket. Ensure that log is 

firmly positioned and there is no side-to-side move-

ment.

4.  Place the front log on top of the burner, use bottom 

holes to locate the logs on top of the studs.

5.  Place the front right log on top of the burner, Use 

bottom holes to locate the logs on top of the studs.

FP383

GF383   NVC

11/20/96

REMOVE LOUVRE/GRILLE

Glass Panel

Louvre 

Top 

Assembly

1.

2.

Fig. 10   Louvre install and removal.

Window Frame Assembly Removal

1.  Turn gas off.

2.  Let the unit cool if it has been operating.

3.  Remove louvre top assembly. (Refer to Louvre Re-

moval section.)

4.  Open louvre bottom assembly.

5.  Release the two clamps at the bottom of the window 

frame by pulling down on the clamp handles. 

6.  Lift off the window frame assembly as shown. (Fig. 

11)

7.  To reinstall window frame assembly, follow the 

above procedure in reverse.