Majestic SHR36 Homeowner's Installation & Operating Manual - Safety Information

Manual is about: Majestic SHR Series Woodburning Fireplace

Summary of SHR36

  • Page 1

    Shr series woodburning fireplace homeowner's installation & operating manual for models: shr36 shr42a shr48 shr52 underwriter's laboratories report no. Mh6018 do not discard this manual: retain for future use. 20001384 7/04 rev. 13 ™ 410 admiral blvd. • mississauga, ontario, canada l5t 2n6 • 905-670...

  • Page 2: Safety Information

    2 shr series woodburning fireplace 20001384 safety information please read this manual before installing and using fireplace. Important: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void ...

  • Page 3

    3 shr series woodburning fireplaces 20001384 rough opening height 42" (1067mm) 52 ¹⁄₄ " (1327mm) 48 ¹⁄₈ " (1222mm) ³⁄₄ " ³⁄₄ " 28 ¹⁄₂ " (724mm) 7⁷⁄₁₆ " (189mm) 13 ³⁄₈ " dia. (340mm) rough opening width 53 ³⁄₄ " rough opening depth 65 ¹⁄₈ " (1654mm) 65 ¹⁄₈ " (1654mm) 92¹¹⁄₈ " (2340mm) 10¹⁄₂ " (267mm)...

  • Page 4

    4 shr series woodburning fireplace 20001384 28¹⁄₂ " (724mm) 7 ³⁄₄ " (197mm) 48" (1219mm) 58 ¹⁄₄ " (1480mm) 48 ¹⁄₂ " (1232mm) ³⁄₄ " ³⁄₄ " 7⁷⁄₁₆ " (189mm) 13 ³⁄₈ " dia. (340mm) rough opening width 59 ³⁄₄ " rough opening height rough opening depth 66 ³⁄₈ " (1686mm) 66 ³⁄₈ " (1686mm) 93⁷⁄₈ " (2384mm) 10...

  • Page 5

    5 shr series woodburning fireplaces 20001384 chase installation insulation methods shown are optional for cold climate, not a requirement for unit operation. Fp554a fig. 5 fireplace and chase parts identification. (shr48 shown) termination cap storm collar pan flashing batt insulation (cut out aroun...

  • Page 6

    6 shr series woodburning fireplace 20001384 chimney requirements - offset installations 0 0 0 0 0 3" 11" 1 0 0 0 0 8 ¹⁄₄ " 20" 0 1 0 0 0 11 ¹⁄₄ " 25 ¹⁄₄ " 2 0 0 0 0 13 ¹⁄₂ " 29 ¹⁄₄ " 1 1 0 0 0 16 ¹⁄₂ " 34 ¹⁄₄ " 0 0 1 0 0 20 ¹⁄₄ " 40 ³⁄₄ " 2 1 0 0 0 21 ³⁄₄ " 43 ¹⁄₂ " 0 0 0 1 0 26 ¹⁄₄ " 51 ¹⁄₄ " 0 1 1...

  • Page 7: Planning Information

    7 shr series woodburning fireplaces 20001384 planning information the ten foot rule major u.S. Building codes specify a minimum chimney height above the roof top. The “ten foot rule” is a fire safety rule and not a draft rule. To ensure proper draft, it is recommended that you always meet or exceed ...

  • Page 8: Installation

    8 shr series woodburning fireplace 20001384 installation chimney supports the chimney system is supported by the fireplace for vertical chimney heights less than 30 feet above the hearth. Chimney supports are required if the vertical height exceeds 30 feet with 11cf chimneys. Locate chimney supports...

  • Page 9

    9 shr series woodburning fireplaces 20001384 framing framing can be constructed before or after the fireplace is set in place, however, most installers build the frame before setting the fireplace. Frame fireplace with 2 x 4 lumber or heavier materials. Refer to framing dimensions in figures 1 - 4 f...

  • Page 10

    10 shr series woodburning fireplace 20001384 angle of chimney at ceiling size of chimney vertical 30˚ 11" cf 2-wall fs2a 17 ¹⁄₂ " x 17 ¹⁄₂ " fs6a 17 ⁷⁄₈ " x 29 ⁵⁄₈ " chimney hole size fp548shr fig. 14 ceiling chimney hole size necessary for installing firestop spacer. Fp556shr fig. 13 locate centerl...

  • Page 11

    11 shr series woodburning fireplaces 20001384 the inside dimension of the frame must be the same as the hole size selected from figure 11 in order to provide the required 2 inches of air space between the outside diameter of the chimney and the edges of the framed ceiling hole. New framing members e...

  • Page 12

    12 shr series woodburning fireplace 20001384 installing the chimney system start by attaching the first chimney section to the collar on top of the fireplace. Install the pipe as pictured in figure 18. When you get a good lock, you will hear the pipe clearly snap together. Once sections are snap-loc...

  • Page 13

    13 shr series woodburning fireplaces 20001384 firestop spacers are not available for, nor are they required on, vertical walls. The chimney components (cf11) used on the shr series fireplaces have been tested and approved with the area where the outer pipe slides through the firestop spacer sealed w...

  • Page 14

    14 shr series woodburning fireplace 20001384 installing top housing or termination follow the installation instructions provided with the chimney termination you have selected. Installing chimney in a chase refer to page 5, figure 4 for an illustration of a typical chase installation. Caution: treat...

  • Page 15

    15 shr series woodburning fireplaces 20001384 stud 2 x 4 header ledge bracket surround must be sealed with noncombustible material noncombustible decorative facing finished wall fp1166 fig. 24 fireplace surround flush with finished wall. Finished wall framing shield fp1277 fig. 23 shr52 framing shie...

  • Page 16

    16 shr series woodburning fireplace 20001384 finished wall stud noncombustible decorative facing must be sealed with noncombustible material surround 2 x 4 finished header covered wall ledge bracket fp1167 fig. 25 facing on fireplace surround flush with finished wall. Caution: do not place finishing...

  • Page 17

    17 shr series woodburning fireplaces 20001384 side wall protection adjacent combustible side walls that are within dimen- sions shown in figure 29 of fireplace opening must be protected with wall shield model sp40 or a specifically built wall shield described in figure 28. The special wall shield de...

  • Page 18

    18 shr series woodburning fireplace 20001384 fp532shr fig. 29 combustible side wall protection and hearth extension dimensions. Minimum wall clearances with noncombustible surround facing without noncombustible surround facing minimum hearth extension dimensions (for on-site construction) g h g j se...

  • Page 19

    19 shr series woodburning fireplaces 20001384 pipe. Material should be inserted from outside of the fireplace and packed tightly to totally seal between the pipe and tube. Note: gas pipe should not come in contact with any wood structures until it has reached a point at least one (1) inch away from ...

  • Page 20

    1 2 3 4 5 6 7 8 a b c 9 10 11 d cfm specialty home products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. 1384 shr36/42a/48/52 woodburning fireplace for units fh30ro, gh40ro, hh30ro, ih10ro item/model ...

  • Page 21: Accessories

    Description designed to enclose the fireplace opening with glass doors allowing the fire to remain visible. Available in polished, brushed brass, black and pewter provides outside air for fuel conbustion in the firebox. This accessory must be installed before fireplace is installed. Located on the f...

  • Page 22

    22 shr series woodburning fireplace 20001384 accessory description model no. Contemporary flashing contemporary chase top termina- tion contemporary round top termina- tion extended round top chimney sections chimney elbows top housing with upper baffle required for contemporary top termination on t...

  • Page 23

    23 shr series woodburning fireplaces 20001384 ™ limited warranty & 30 year protection plan for majestic fireplaces ® pre-engineered fireplace systems cfm specialty home products warrants its majestic fireplaces® pre-engineered fireplace (“fireplace”) and the cfm specialty home products supplied fire...

  • Page 24

    © cfm specialty home products 410 admiral blvd. • mississauga, ontario, canada l5t 2n6 • 905-670-7777 www.Majesticproducts.Com • www.Vermontcastings.Com cfm specialty home products.