Summary of MX-30
Page 1
Operating guide mx-30 mx-60 mixer amplifier.
Page 2: Warning
Warning 1. Read these instructions - ali the safety and operating instructions sh ould be read before this product is operated. 2. Retain these instructions - the safety and operating instructions sh ould be retained for future reference. 3. Heed all wamings -ali warnings on the appliance and in t...
Page 3: Contents
Contents features ................................................................................................................................................. 1 functional components ...................................................................................................................
Page 4: Features
1 features 30w/60w mixer amplifier 2 microphone inputs; gain control for mic 1, level adjustable from microphone to aux input one aux / cd input, switchable independent volume control for all the inputs, and master volume control with 6khz, 1khz, and 150hz tone control led for output level and prote...
Page 5: Functional Components
Functional components front panel 1. Mic1 volume 2. Mic2 volume 3. Aux/cd volume 4. Bass 150hz 5. Middle 1khz 6. Treble 6khz 7. Master volume 8. Signal led 9. -10db led 10. Power switch 11. Power led 12. Clip led 13. Protect led.
Page 6: Rear Panel
3 rear panel 1. Appliance inlet 2. Fuse used in inlet 3. Ground screw 4. Manual priority terminals 5. Speakers output terminals 6. Aux input 7. Cd input 8. Aux/cd selector switch 9. Mic2 input-unbalanced 10. Mic1 input-balanced.
Page 7: Operation
4 operation equalizer controls three different controls for three frequency bands. Those volume controls will increase or decrease bass and treble or add some presence to the sound. Manual priority terminals these two terminals, when shorted, will mute incoming signal from aux and cd inputs, thus gi...
Page 8
5 microphone2 mic2 input is a unbalanced standard 1/4〃mono jack on the rear panel . Wiring is as follows aux/cd connection aux/cd input is two phono sockets .These inputs are configured as aux or cd inputs speaker output these terminals are offering 3 low-z outputs 4Ω, 8Ω, 16Ω depending on your spea...
Page 9
6 speakers to be placed on your distribution line is in relation to the power allocated to each speaker. The total wattage set on the secondary side of the transformers on your speaker line must not exceed the maximum rms output power: 30w for mx30 or 60w for mx60. Failure to respect this may cause ...
Page 10: Specifications
7 specifications mx-30w mx-60w output power 30w 60w fuse t1.0al 250v t1.6al 250v thd at rated power 2.5% speaker outputs 4Ω, 8Ω, 16Ω, hi-z output ( 70v/100v choose 1 of these 2 ) frequency response 100 hz – 20 khz mic2 input 3 mv @ 600 Ω aux inputs 150 mv @ 50 kΩ cd inputs 300 mv @ 50 kΩ mic1 input ...
Page 11: Block Diagram
8 block diagram.