Make Noise PHONOGENE Owner's Manual - page 2
2
Proper installation of included power cable on mod-
ule. Please note the RED BAND.
Installation:
The Make Noise Phonogene is an electronic signal processor/ generator
requiring 70mA of +/-12V regulated power and properly formatted
distribution receptacle to operate. It is designed to be used within the euro
format modular synthesizer system.
Go to http://www.doepfer.de/a100_man/a100t_e.htm
for the details of this format.
To install, find 20HP of space in your euro-rack synthesizer system, confirm
proper installation of included power cable on backside of module (see pic-
ture below), plug the 16pin end power cable into the euro-rack style power
distribution board, minding the polarity so that the RED stripe on the cable
is oriented to the NEGATIVE 12 volt supply line. This is USUALLY at the bot-
tom. Please refer to your case manufacturers’ specifications for location of the
negative supply.