Makeblock Codeybot User Manual - page 4
Product Diagram
Battery Information
Charging Codeybot
▲ Note: Before first use, please make sure to full charge Codeybot.
Codeybot comes with a built-in 2000mAh lithium battery. It supports
up to 3 hours of continuous playing with a single charge.
Connect the micro USB end of the USB cable to the Codeybot.
Connect the other end of the USB cable to PC, or any power
resource with 5V/1A.
The side light will turn green and solid on when the battery is fully
charged.
5
6
When the battery grows weak, Codeybot will move very slowly and
may not be responsive to your control. Check battery level by LED
panel or side light:
Important Battery Information
Battery Level
LED P
anel
Dual Enc
oder Mot
or
2 x Stereo Speak
er
Wi-Fi&2.4G
RGB Side Light
Gyrosc
ope
Magnetic Dock
2000mAh Batt
ery
In the event of battery leakage, avoid contact with skin and eyes.
If your robot is charging and you notice a suspicious smell or noise
or observe smoke around Codeybot, disconnect it immediately
and turn off all sources of heat or flame.
You are solely liable for ensuring that the lithium battery is used
correctly (charging, storage, etc). Makeblock and its distributors
shall have no liability for injury or damage to persons or property
associated with lithium battery use. Make sure to fully recharge the
battery at least once every month even if it’s not going to be played
with for some time.
The built-in lithium battery cannot be replaced
Battery Status
LED Panel Indication
Side Light
Other Action
Out of Power
" Bye" before shut down
N/A
Can’t be
turned on
Low
Flashing Red
Charging
Breathing Blue
N/A
Fully Charged
N/A
Solid Green
N/A
N/A
Charging Battery Animation
Slow movement and
not responsive to your
control