I n s t r u c t i o n m a n u a l warning: for your personal safety, read and understand before using. Save these instructions for future reference. English cordless circular saw with dust collection model 5026d model 5036d model 5046d 001322.
2 specifications • due to our continuing programme of research and development, the specifications herein are subject to change without notice. • note: specifications may differ from country to country. Intended use the tool is intended for performing lengthways and crossways straight cuts and mitre...
3 safety instructions ena002-2 warning: when using battery operated tools basic safety precautions, including the following, should be followed to reduce the risk of fire, leaking batteries and personal injury: read these instructions before operating this product and save these instructions. For sa...
4 additional safety rules for tool enb077-1 1. Be aware that this tool is always in an operating condition, because it does not have to be plugged into an electrical outlet. 2. Wear hearing protection. 3. Keep guards in place and in working order. Never wedge or tie lower guard open. Check operation...
5 15. Avoid cutting nails. Inspect for and remove all nails from lumber before cutting. 16. Operate with proper hand support and proper workpiece support. Warning: it is important to support the workpiece properly and to hold the saw firmly to prevent loss of control which could cause personal injur...
6 important safety instructions for battery cartridge enc004-1 1. Before using battery cartridge, read all instruc- tions and cautionary markings on (1) battery charger, (2) battery, and (3) product using bat- tery. 2. Do not disassemble battery cartridge. 3. If operating time has become excessively...
7 functional description caution: • always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge • always switch off the tool before insertion or removal of the battery cartridge. • to re...
8 dust collection caution: • never cut workpieces covered/stained with thinner, gasoline, oil or the like. If the dust box is stained with them, it may crack, causing an injury to operator. This tool is equipped with the dust box to collect dust and cut chips. When the dust box is about two thirds f...
9 to install the blade, follow the removal procedure in reverse. Install the cup washer, inner flange, saw blade, outer flange and hex bolt on the spindle in that order. Be sure to tighten the hex bolt clockwise securely. After installing the blade, install the dust box and tighten the clamping scre...
10 for 5046d only when you cut angle materials or the like, the lower guard may rest on the angle. If so, tilt other rear of the tool to prevent this. When cutting thin sheet metals such as corrugated metal, always cut them at a position more than 20 mm (25/32”) away from the edge. If you cut them a...
11 maintenance caution: • always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. Replacing carbon brushes remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon b...
Makita corporation 884267c993.
