6203d 6213d/6313d 6233d/6333d cordless driver drill.
2 specifications model 6203d 6213d 6313d 6233d 6333d capacities steel .............................. 10 mm 10 mm 13 mm 10 mm 13 mm wood ............................. 25 mm 25 mm 25 mm 25 mm 25 mm wood screw ................... 6.4 x 76 mm 6.4 x 76 mm 6.4 x 76 mm 6.4 x 76 mm 6.4 x 76 mm machine screw...
3 1 2 3 4 5 6 7 8 19 20 21 22 18 17 16 1 6 14 1 2 1 6 14 12 11 11 12 13 14 15 10 9 8 7 6 5 3 4 2 1 2.
4 9 10 11 symbols the followings show the symbols used for the tool. Be sure that you understand their meaning before use. Note: the recycling method may differ from country to country, or state (province) to state (province). Consult with your near- est makita authorized service center or distribut...
5 english explanation of general view 1 button 2 battery cartridge 3 charging light 4 battery charger 5 tighten 6 sleeve 7 ring 8 bit 9 bit holder 10 switch trigger 11 reversing switch lever 12 a side 13 b side 14 clockwise 15 counterclockwise 16 low speed 17 high speed 18 speed change lever 19 adju...
6 21. Disposal of battery – ensure battery is disposed of safety as instructed by the manufacturer. Important safety instructions for charger & battery cartridge enc001-2 1. Save these instructions — this manual contains important safety and operating instruc- tions for battery charger. 2. Before us...
7 charging (fig. 2) your new battery cartridge is not charged. You will need to charge it before use. Use the battery charger to charge the battery cartridge. Plug the battery charger into the proper ac voltage source. The charging light will flash in green color. Insert the bat- tery cartridge so t...
8 switch action (fig. 5) caution: before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “off” position when released. To start the tool, simply pull the trigger. Tool speed is increased by increasing pressure on the tri...
9 maintenance caution: always be sure that the tool is switched off and the bat- tery cartridge is removed before carrying out any work on the tool. Replacement of carbon brushes (fig. 10 & 11) replace carbon brushes when they are worn down to the limit mark. Both identical carbon brushes should be ...
10
11.
Makita corporation 884057a223.
