Makita 6214D Instruction Manual

Other manuals for 6214D: Instruction Manual

Summary of 6214D

  • Page 1

    6214d 6314d cordless driver drill.

  • Page 2

    2 specifications model 6214d 6314d capacities steel ................................................................................................ 10 mm 13 mm wood ............................................................................................... 21 mm 24 mm wood screw ..................

  • Page 3

    3 1 2 3 4 5 6 7 8 1 2 2 3 4 16 15 14 6 7 5 8 17 18 19 20 10 9 11 12 13 9 21 22.

  • Page 4

    4 9 10 11 23 24 25 symbols the following show the symbols used for the tool. Be sure that you understand their meaning before use. Note: the recycling method may differ from country to country, or state (province) to state (province). Consult with your nearest makita authorized service center or dis...

  • Page 5

    5 english explanation of general view 1 button 2 battery cartridge 3 charging light 4 fast charger 5 tighten 6 sleeve 7 ring 8 switch trigger 9 reversing switch lever 10 a side 11 b side 12 clockwise 13 counterclockwise 14 low speed 15 high speed 16 speed change lever 17 adjusting ring 18 graduation...

  • Page 6

    6 21. Disposal of battery – ensure battery is disposed of safety as instructed by the manufacturer. Important safety instructions for charger & battery cartridge enc001-3 1. Save these instructions — this manual contains important safety and operating instruc- tions for battery charger. 2. Before us...

  • Page 7

    7 charging (fig. 2) plug the fast charger into the proper ac voltage source. The charging light will flash in green color. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective mark- ings on the fast charger. Insert the c...

  • Page 8

    8 caution: • always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned half-way between the “i” side and “ii” side, the tool may be damaged. • do not use the speed change lever while the tool is run- ning. The tool may be damaged....

  • Page 9

    9 accessories caution: these accessories or attachments are recommended for use with your makitaauthorise tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attach- ments should be used only in the proper and i...

  • Page 10

    10 • rubber pad assembly • wool bonnet 100 • battery cartridge 1202a • battery charger dc1413 • foam polished pad 125 • battery cartridge 1222/1233/1234/1235 • battery cover • set plate • plastic carrying case.

  • Page 11

    11.

  • Page 12

    Makita corporation anjo, aichi, japan made in japan 884180-224.