6223d cordless driver drill.
2 specifications model 6223d capacities steel .................................................................................................................................................................. 10 mm wood ...................................................................................
3 2 1 2 3 4 5 7 6 8 9 11 10 12 1 1 2 3 4 5 6 7.
4 symbols the following show the symbols used for the tool. Be sure that you understand their meaning before use. Note: the recycling method may differ from country to country, or state (province) to state (province). Consult with your nearest makita authorized service center or distributor. ❏ indoo...
5 english explanation of general view 1 battery cartridge 2 button 3 charging light 4 battery charger 5 sleeve 6 tighten 7 ring 8 switch trigger 9 reversing switch 10 pointer 11 drill marking 12 adjusting ring safety instructions warning! When using battery operated tools basic safety precautions, i...
6 important safety instructions for charger & battery cartridge enc001-3 1. Save these instructions — this manual contains important safety and operating instruc- tions for battery charger. 2. Before using battery charger, read all instruc- tions and cautionary markings on (1) battery charger, (2) b...
7 operating instructions installing or removing battery cartridge (fig. 1) • always switch off the tool before insertion or removal of the battery cartridge. • to remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. • to insert the batter...
8 for dc1414 plug the battery charger into the proper a/c voltage source. The charging light will flash in green color. Insert the bat- tery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the battery charger. Insert the c...
9 note: the adjusting ring cannot be locked with the pointer posi- tioned half-way between the numbers. Screwdriving operation (fig. 7) place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the trigger...
10
11.
Makita corporation 884130c229.
