I n s t r u c t i o n m a n u a l warning: for your personal safety, read and understand before using. Save these instructions for future reference. W w w . M a k i t a t o o l s . C o m angle drill 13 mm (1/2”) model 6300lr 002994 double insulation.
2 specifications • manufacturer reserves the right to change specifications without notice. • specifications may differ from country to country. General safety rules usa002-2 (for all tools) warning: read and understand all instructions. Failure to follow all instructions listed below, may result in...
3 5. Avoid body contact with grounded sur- faces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. 6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7....
4 use proper extension cord: make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows t...
5 functional description caution: • always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action caution: • before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “off” position when...
6 to install the drill chuck, screw it onto the angle head firmly (do not overtighten) and replace the screw removed earlier from the drill chuck. It screws in counterclockwise. Fit the sleeve onto the hex end of the drill spindle and then slip on the joint, tightening the joint bolt (a) with the wr...
7 drilling in metal to prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. Place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass ...
8 use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. To maintain product safety and reliability, repairs, any other maintenance or adjustment should be performed by makita authorized or factory service centers, a...
9 first-class postage required post office will not deliver without proper postage. Makita u.S.A., inc. 14930 northam street la mirada, ca 90638-5753 fold cut.
10 1. This product was purchased from: home center hardware/lumber store tool distributor industrial supply construction supply other ( ) 3. How did you learn about this product: magazine from dealer newspaper store display catalog radio exhibition from friend previous usage other ( ) 2. Use of the ...
11 factory service centers 1-800-4-makita retain this portion for your records alabama 2365 pelham parkway pelham, al 35124 (205) 620-1791 arizona 3707 e. Broadway rd., ste. 6 phoenix, az 85040 (602) 437-2850 arkansas shackleford shopping center 240 south shackleford rd., ste. C little rock, ar 7221...
Warning some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the state of california to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, • crystalline ...
