Makita 8406C Instruction Manual - Functional Description
5
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
1
2
007625
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop. For continuous operation, pull
the switch trigger and then push in the lock button. To
stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed change
1
007606
To change the speed, turn the speed change lever to the
"2" position for high speed or "1" position for low speed.
Be sure that the speed change lever is set to the correct
position before operation. Use the right speed for your
job.
CAUTION:
•
Always set the speed change lever fully to the
correct position. If you operate the tool with the
speed change lever positioned halfway between
the "1" position and "2" position, the tool may be
damaged.
Speed adjusting dial
1
2
007607
The tool speed can be infinitely adjusted from 900 and
4,000 min
-1
with the speed adjusting dial and speed
change lever. Faster speeds are obtained by setting the
dial to a higher number. Number of blows per minute
varies according to the tool speed. The following charts
indicate resultant tool speeds in various lever and dial
positions.
When the speed change lever is set to the "1" position.
-1
1
007614
When the speed change lever is set to the "2" position.
-1
1
007608
Refer to the table for selecting the tool speed most
suitable for your workpiece and bit.
1. Numbers on dial
1. Numbers on dial
1. Handle
2. Speed adjusting
dial
1. Speed change
lever
1. Lock button
2. Switch trigger