1 english ( o rigina l in st ruct ions) instruction manual warning: for your personal safety, read and understand before using. Save these instructions for future reference. Cordless driver drill bdf444 bdf454 008981.
2 english specifications model bdf444 bdf454 steel 13 mm 13 mm wood 50 mm 65 mm wood screw 6 mm x 75 mm 10 mm x 89 mm capacities machine screw 6 mm high (2) 0 - 1,700 no load speed (min -1 ) low (1) 0 - 400 overall length 231 mm net weight 2.2 kg 2.3 kg rated voltage d.C. 14.4 v d.C. 18 v • due to o...
3 personal safety 10. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. ...
4 geb001-4 specific safety rules do not let comfort or familiarity with product (gained from repeated use) replace strict adherence to drill safety rules. If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. 1. Use auxiliary handle(s), if supplied with the tool...
5 functional description caution: • always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 1 2 3 008993 • always switch off the tool before insertion or removal of the battery cartr...
6 speed change 1 008984 to change the speed, first switch off the tool and then slide the speed change lever to the "2" side for high speed or, "1" side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job. Caution: • al...
7 installing or removing driver bit or drill bit 1 008987 turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck. To remove the bit, turn the sleeve counterclockwise. Installing bit holder 1 2 006725 fi...
8 drilling in metal to prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. Place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass ...
9 1 2 006304 reinstall the rear cover and tighten two screws securely. To maintain product safety and reliability, repairs, any other maintenance or adjustment should be performed by makita authorized service centers, always using makita replacement parts. Accessories caution: • these accessories or...
10
11.
12 makita corporation 884811a9.
