1 english ( o rigina l in st ruct ions) instruction manual important: read before using. Cordless angle drill da330d da331d 013258.
2 english (original instructions) specifications model da330d da331d steel 10 mm 10 mm capacities wood 12 mm 12 mm no load speed (min -1 ) 0 - 800 0 - 800 overall length 298 mm 310 mm net weight 1.1 kg 1.1 kg rated voltage d.C. 10.8 v d.C. 10.8 v • due to our continuing program of research and devel...
3 and are manufactured in accordance with the following standards or standardised documents: en60745 the technical documentation is kept by: makita international europe ltd. Technical department, michigan drive, tongwell, milton keynes, bucks mk15 8jd, england 8.5.2012 000230 tomoyasu kato director ...
4 power tool use and care 17. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 18. Do not use the power tool if the switch does not turn it on and off. Any power tool that cann...
5 enc009-1 important safety instructions for battery cartridge 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. 2. Do not disassemble battery cartridge. 3. If operating time has become excessively sho...
6 • overloaded: the tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded. Then pull the switch trigger again to restart. • low battery voltage: the ...
7 assembly caution: • always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing drill bit for model da330d 1 013252 to install the bit, place it in the chuck as far as it will go. Tighten the chuck by hand. Plac...
8 caution: • pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. • there is a tremendous force exerted on the tool/bit at the time of h...
9.
10
11.
12 makita corporation anjo, aichi, japan www.Makita.Com 885179-222.
