Makita DC36RA Technical Information - page 3
[1]-2. Terminal unit, Charging circuit
DISASSEMBLING
(1) Disconnect Connector CN202 and remove Lead wires (blue and brown) from Charging circuit with Soldering iron.
(Fig. 3).
(2) Remove Terminal unit from Terminal base (Fig. 4).
Fig. 3
Fig. 4
Charging circuit
Terminal unit
Lead wire (brown)
Lead wire (blue)
Connector CN203
Conector CN202
(Enlarged fig.)
Terminal unit
Terminal base
Compression spring 4
(233194-8)
P 3/ 5
R
epair
(1) Install Lead wires as described. (Fig. 5 and 6)
(2) Take the reverse step of Figs. 3 and 4.
Fig. 5
Fig. 6
ASSEMBLING
2. Locate Lead wires in the
described place.
Note: Do not pinch them
with ribs.
4. Band Lead wires with
Clip.
1. Route Lead wires between ribs.
Note: Do not pinch them with ribs.
Rib on Charger case
3. Fix Connectors CN202
and CN203 securely.
Route Lead wires
in the described position.
Charging
circuit