Instruction manual cordless jig saw jv101d eng lish: o rig in al in stru cti on s read before use..
2 english specifications model: jv101d length of stroke 18 mm strokes per minute 0 - 2,900 min -1 blade type b type max. Cutting capacities wood 65 mm mild steel 2 mm aluminum 4 mm rated voltage d.C. 10.8 v battery cartridge bl1015, bl1020b bl1040b overall length 232 mm 250 mm net weight 1.7 kg 1.9 ...
3 english 23.9.2015 yasushi fukaya director makita, jan-baptist vinkstraat 2, 3070, belgium general power tool safety warnings warning: read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all wa...
4 english battery tool use and care 1. Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. 2. Use power tools only with specifically desig- nated battery packs. Use of any...
5 english save these instructions. Caution: only use genuine makita batteries. Use of non-genuine makita batteries, or batteries that have been altered, may result in the battery bursting causing fires, personal injury and damage. It will also void the makita warranty for the makita tool and charger...
6 english indicator lamps remaining capacity lighted off 75% to 100% 50% to 75% 25% to 50% 0% to 25% note: depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Selecting the cutting action 1 fig.3 ► 1. Cutting action changing le...
7 english 1 2 3 fig.5 ► 1. Jig saw blade holder 2. Bolt 3. Hex wrench with the blade teeth facing forward, insert the jig saw blade into the jig saw blade holder as far as it will go. Make sure that the back edge of the blade fits into the roller. Then tighten the bolt clockwise to secure the blade....
8 english bevel cutting caution: always be sure that the tool is switched off and the battery cartridge is removed before tilting the base. Caution: raise the dust cover all the way before making bevel cuts. With the base tilted, you can make bevel cuts at any angle between 0° and 45° (left or right...
9 english 1. Tilt the tool up on the front edge of the base with the jig saw blade point positioned just above the work- piece surface. 2. Apply pressure to the tool so that the front edge of the base will not move when you switch on the tool and gently lower the back end of the tool slowly. 3. As t...
10 english circular cuts when cutting circles or arcs of 170 mm or less in radius, install the rip fence as follows. 1 fig.20 ► 1. Rip fence (guide rule) 1. Insert the rip fence into the rectangular hole on the side of the base with the fence guide facing up. 2. Insert the circular guide pin through...
11 english optional accessories caution: these accessories or attachments are recommended for use with your makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you...
Www.Makita.Com makita jan-baptist vinkstraat 2, 3070, belgium makita corporation anjo, aichi, japan 885494-224 en 20151113.
