Makita M4001 Instruction Manual - Maintenance
4
ENGLISH
CAUTION:
•
Always hold the tool only by the handle when
performing an operation. Do not touch the metal
part.
•
Do not use the tool for blowing air into objects,
like rubber rafting, balls or other inlatable prod-
ucts. Increased motor revolution may cause
dangerous fan breakage.
Blowing
1
2
3
► 1. Nozzle 2. Blower outlet 3. Pin
For dust blowing, attach nozzle to blower outlet. Turn it
clockwise until it clicks.
Dust suction (optional accessory)
1
2
3
4
► 1. Dust bag 2. Blower outlet 3. Suction inlet
4. Nozzle
For dust suction, it nozzle onto suction inlet and dust
bag onto blower outlet. Turn them clockwise until it
clicks.
1
► 1. Fastener
After the bag ills with dust, empty the contents of the
dust bag into a dust bin by releasing the fastener.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
•
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
Replacing carbon brushes
1
► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.