Quick guide wlan repeater eco mt4218.
2 en overview reset hole status leds lan socket configuration management is done via web browser, device is responding at address 192.168.2.1, default user: admin, default password: admin. In or- der to configure device you need to establish connection via lan (connect your pc com- puter with ethern...
3 en click “ok” and close network properties. Now open your web browser and enter http://192.168.2.1 if prompted enter default user name (admin) and pass- word (admin). If you want to extend your local wifi network select op- tion “repeater”. Next click “scan” to search available wifi networks..
4 en select desired network, if prob- lem with difference in broadcast channel occur – following win- dows will appear. Click “ok” on both windows in order to set the same channel of broadcast when you use repeater mode..
5 en now enter password for wifi network you want to extend. Default name and password of re- peater wifi can be edited by user. Enter password click “save/apply” and wait until new setting will be stored. Device will reboot automati- cally..
6 en now you can connect to new wifi network “7links-repeater”. Go to wireless network and click “refresh network list”. Configuration is done. Select “7links-repeater” and enter password (default: 12345678). Changing password for management website enter new password..
7 en factory reset whenever you noticed strange behavior of device or you have forgotten password you can restore factory settings, simply put straighten paper clip into reset hole for 10 seconds (device must be powered from elec- tric outlet). Troubleshooting regarding repeater mode q: after config...
8 en.
