Media5 Mediatrix 4102 Installation Manual
Discover the Power of
5
© 2012, Media5 Corporation
Document Revision 16
Mediatrix 4102/4102S
Installation – SIP
Warning:
In the following installation procedures, do not disconnect the
Mediatrix 4102 while the LEDs are flashing.
Thank you for choosing the Mediatrix 4102. This Quick Start will help you to properly connect all of the cables to the Mediatrix 4102 and access its web
interface.
Please read the Mediatrix 4102 Hardware Installation Guide for detailed installation information and the Mediatrix 4102 Software
Configuration Guide for in-depth configuration information.
Step 1
Connecting Cables
The following describes how to connect the various cables to the Mediatrix 4102.
Before you begin, make sure that you have a working network connection. Then follow these steps to install the Mediatrix 4102.
1.
Before you begin, be sure that the Mediatrix 4102 is powered off.
2.
Connect the power cord to its connector on the Mediatrix 4102. Do not connect
the other end of the power cord to an electrical outlet.
3.
Connect analog telephones or fax machines into the
Phone-Fax 1 and Phone-
Fax 2
connectors.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
4.
Connect a 10/100 BaseT Ethernet RJ-45 cable into the
WAN
connector of the Mediatrix 4102; connect the other end to a compatible Ethernet
interface that supplies TCP/IP network access (e.g., router, switch, hub or computer).
You can either use a crossover or straight Ethernet cable because it performs automatic MDI / MDIX detection.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
5.
Connect a 10/100 BaseT Ethernet RJ-45 cable into the
LAN
connector of the Mediatrix 4102 and connect the other end to the network card of
a computer.
You can either use a crossover or straight Ethernet cable because it performs automatic MDI / MDIX detection. Use a standard
telecommunication cord with a minimum of 26 AWG wire size.
Step 2
IP Address Discovery or Configuration
The purpose of this section is to be able to contact the Mediatrix 4102's web interface to start with unit configuration.
Once the physical connection is complete, you will need to power on the Mediatrix 4102 and find out the IP address it is using. The Mediatrix 4102's IP
address can be set either dynamically or statically. The default behaviour of the Mediatrix 4102 is to try to obtain a dynamic IP address through a DHCP
server.
Dynamic IPv4 Address Discovery
Before connecting the Mediatrix 4102 to the network, Media5 strongly suggests that you reserve an IP address in your DHCP server for the unit you are
about to connect. DHCP servers reserve IP addresses for specific devices by using a unique identifier for each device. The Mediatrix 4102's unique
identifier is its media access control (MAC) address. The MAC address appears on the label located on the bottom side of the unit.
Note:
Make sure any IPv4 DHCP-provided address is outside of 192.168.0.x or otherwise, contact the unit on the LAN port and change the LAN
IP address for an address that does not clash with the DHCP-provided address.
2
3
4
5