Medifab shuttle Instruction - To Open The Stroller
5
MOON BUGGY SET-UP
TO OPEN THE STROLLER
A
Lay the chassis down flat and release the frame lock
catch
B
Adjust the handle to the user upright position by
simultaneously pressing the red buttons on the inside
of the handle Grasp the handle and lift upwards
allowing the chassis to extend and click into position
C
Check the stroller is ready for use by lifting the handle
The stroller should not collapse
TO INSTALL THE FRONT SWIVEL WHEEL
A
Remove the plastic protector (Where Fitted) from the front forks
B
Push the front wheel axle fully into the wheel forks
C
Place the securing washer on both sides, ensure the tabs in the washers are located
into the circular holes just above
D
Tighten the front wheel axle by turning the quick release hub in a clockwise rotation
and fold lever to lock
NOTE:
Pneumatic front and rear tyres can be inflated with pump (where supplied)
or a bicycle pump or at garage air pump and they have a maximum inflation
pressure of 2.4 bar (35 p.s.i).
TO INSTALL THE REAR WHEELS
A
Push each rear wheel into the chassis until
they lock into position
B
Check the wheels are correctly fitted by
trying to pull them out
NOTE:
The rear wheels can be removed
for more compact storage. Do this by
lifting the lock lever on the top of the rear
wheel housing, then pull the wheel out.