Medion MD6421 Operation Manual

Manual is about: 13" COLOR TV/DVD COMBO

Summary of MD6421

  • Page 1

    P1430 tvd-1310( 0374-04).P65 2002/12/30, pm 05:19 1 oper oper oper oper opera a a a ation manu tion manu tion manu tion manu tion manual al al al al md6421 13" col 13" col 13" col 13" col 13" color or or or or tv/d tv/d tv/d tv/d tv/dvd combo vd combo vd combo vd combo vd combo.

  • Page 2

    2 installation locate the receiver in the room where direct light does not strike the screen. Total dark- ness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. Allow enough space between the receiver and the wall to permit ...

  • Page 3

    3 caution never tamper with any components inside your set, or any other adjustment controls not mentioned in this manual as all television receivers are high voltage instruments. The pic- ture tube is highly evacuated and if broken, glass fragments will be violently expelled. When cleaning, dusting...

  • Page 4

    4 important safety instructions - read before operating equipment this product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. 1. Read instructions - all the safety a...

  • Page 5

    5 15. Outdoor antenna grounding – if an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the national electrical code, ansi/ nfpa 70, provid...

  • Page 6

    6 location of control 23 programming this function is applicable for dvd and cd audio. You can assign the playback sequence according to your preference. For cd audio, you can assign the track sequence while for dvd disc, you can assign both the title and chapter sequence. • cd 1. Press the program ...

  • Page 7

    7 remote control 1. Dvd subtitle button 2. Eject button 3. Mark button 4. Repeat button 5. Audio button 6. Program button 7. Angle button 8. Direction up button 9. Clear button 10. Direction left button 11. Pause/step button 12. Tv channel buttons 13. Fast backward button 14. Stop button 15. Slow pl...

  • Page 8

    8 tv operation picture adjustment ! Press the [menu] key to enter the picture mode. ! Press the [ ] / [ ] keys to select the desired adjustment. ! Press [ ] / [ ] keys to adjust the level of selected item. The level setting can be adjusted from “0” to “100”. ! Press [ ] / [ ] keys to set the blue ba...

  • Page 9

    9 auto memory/scan for channels ! Press the [ ] or [ ] key to select “auto memory”, then press the [ ] key start the auto memory process. ! If signal is detected, the current channel is entered in the memory and proceeds to the next receivable channel. ! After the highest receivable channel is detec...

  • Page 10

    10 v-chip pin no. Abcdefgh...01234567..... Xyz.... 123.... Text display function ! Press the ccd text button to display closed caption text. Note: the ccd and text function is available only when the current channel signal contains this information. V-chip function for parental controls v-chip menu ...

  • Page 11

    11 2. Setting tv guidelines rating system. ! In the tv guidelines rating setting menu, a rating level can be changed by [ ] or [ ] button. There are 7 level rating system. [ ] button - - (non) –>tv-y –>tv-y7 –>tv-g –>tv-pg –>tv-14 –>tv-ma [ ] button - - (non) data content setting in tv guidelines ! ...

  • Page 12

    12 operating with remote control selecting a tv station with the remote control: 1. Channel number up and down press the ch. " [ ] " or " [ ] " button to select a higher or lower channel number. 2. 0 - 9 digital button to select tv stations using channel numbers 0 - 9, press the desired ch-number. T...

  • Page 13

    13 dvd setup mode • the setup mode provides the menu for the configuration of tv mode, speakers mode, dolby mode and user preference. • item selection in the setup menu is done by using the navigation arrows and the enter key. • to exit the setup menu, choose the exit option in the setup menu and pr...

  • Page 14

    14 angle mark this only works when there is an angle mark on the disc. Select on, the screen shows the mark when playing dvd. • on • off osd (on screen display) language this is used to select the osd language. • english • spanish • german • french captions this option can show or hide the captions....