Mls-200-c 100/95 mbps vdsl2 (long reach ethernet) ethernet bridge (combo interface for copper or coaxial) user’s guide version:1.0.E.
-- i copyright all rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photo copying, recording or otherwise, without the prior written permission of the publisher. Fcc warning this ...
-- 1 introduction mls-200-c is the lre(long reach ethernet) bridge that efficiently extends 10/100 ethernet circuits to 2 wire-networking lan for internet and intranet access. Over 915 meters (3,000feet) at 50/80mbps using existing phone/coaxial wire. This modem will allow ethernet connectivity in e...
-- 2.
-- 3 led indicators on the front panel led status glowing dimming flashing power dc 12 power feeding in not powered n/a lan1~4 link/act lan link disconnected or link failed received or transmit line cpe cpe side mode co side mode n/a line link/act vdsl2 link n/a slow flashing mean link failed or fas...
-- 4 ports on the real panel port name type functions dc in dc 12v connects to the power adapter plug. Config dip sw config for modem lan1~4 rj45 connects to ethernet port on fttx/xdsl modem or switch for internet access. Line/phone rj11 pin 3-4 : connects from wall outlet line in or connects to vds...
-- 5 essential hardware’s items included description purpose vdsl2 ethernet bridge modem main unit dc 12v power adapter (input: 100~240v, 50~60hz, 0.5a) connects from power port of the main unit into a wall outlet.
-- 6 hardware connections the figure about shows how to connect an xdsl modem to a phone line network. Follow the same steps to connect and ethernet device such as hub or ap, to a phone line network. Now you should have connected the ethernet port, line port and the power port to the appropriate dev...
-- 7 troubleshooting the bride had been designed to be a reliable and easy to use connection device. Please refer to the list below to aid in troubleshooting. The power (green) led is off make sure the power adapter is properly plugged into a live electrical outlet. The lan (ethernet) or line link...
-- 8 specifications network standards ieee802.3 10base-t, 10mbit/s ieee802.3u 100base-tx, fast ethernet at 100mbit/s, auto-negoatiaton ieee802.3x full duplex and flow control protocol: transparent to higher layer protocols connectors fast ethernet：four rj45 connectors rj11：one rj11...
-- 9 operating humidity：10％ ~ 90％，non-condensing power requirement external power supply：12v/1a power consumption： physical dimension 155mm(w) x 83mm(d) x 30mm(h) unit weight 380g emissions compliance fcc part 15 class b, ce mark ordering information mls-200 : 1 wan, 2 *10/10...
-- 1 0 appendix (phy link rate reference table) using awg26 copper communication distance(meter) 100m/95m profile line rate (download mbps) 100m/95m profile line rate (upload mbps) 100m/60m profile line rate (download mbps) 100m/60m profile line rate (upload mbps) 100 100 95 100 60 200 100 93 100 60...
-- 11 100/60 phy link rate table 0 20 40 60 80 100 120 100 300 615 121 5 161 5 distance mb ps download mbps upload mbps 100/95 phy link rate table 0 20 40 60 80 100 120 100 300 615 121 5 161 5 distance mb ps download mbps upload mbps 100/95 phy link rate table 0 20 40 60 80 100 120 100 200 300 315 6...
