Meec Tools 060-201 Operating Instructions Manual - Maintenance
EN
56
Drilling in metal and steel
NOTE:
• Sheet metal should always be secured before drilling.
• Place a piece of wood under the workpiece when drilling in thin sheet metal to avoid deformation.
1.
Use high speed steel drills for best results.
2.
Set the drill driver in drilling mode.
3.
Mark the center with a punch to prevent the drill slipping.
4.
Use a suitable lubricant for the workpiece.
5.
Press the power switch carefully, so that you are in full control all the time. Start drilling at low
speed to avoid the drill sliding to the side when you start.
MAINTENANCE
NOTE: Always remove the battery before doing any work on the drill driver.
• Clean the drill driver with a damp cloth.
• Do not use petrol, solvents or detergents that can damage the plastic parts.
• Keep the ventilation openings on the drill driver clean.