Meg Stoves meg-4.5 Inset Installation And Operating Instructions

Summary of meg-4.5 Inset

  • Page 1

    Meg solid fuel stoves manual (24) of 16/06/2010 inset versions supplement installation and operating instructions leave this document with the householder! All meg stoves exceed the safety and performance requirements of european standards independently tested by sgs (notified laboratory no:0608) in...

  • Page 2

    Building regulations are available at www.Soliftec.Com installing a stove is a 'controlled service', the law expects that it is either supervised by a qualified installer or that the building inspector is informed. Check with your local authority. Asbestos: your stove does not contain asbestos, but ...

  • Page 3

    Needed. Don't fill above the level shown in the diagram. Once a bed of cinders has built up, just adding a single log each hour or so is usually all that is needed. Control how fast the fire burns depends on how much air reaches the fuel. The stove has two air controls, one below the window ('primar...

  • Page 4

    Condensation onto cool surfaces inside the stove can be severe if fuel is in any way damp. Use only very dry fuel. Over-firing: it is possible to leave the fire too long with the controls set too high leading to 'over firing', seen as glowing metal parts, excessive chimney temperature and risk of pa...