Mega Catch MCP600 Operation Manual - page 20
18
Replacement of U.V. Bulb (refer to figure 8.2):
Remove the U.V. Bulb by twisting the tube gently until it is able to be removed. Then slot a new
U.V. Bulb into the connector ends and twist the tube gently until it is firmly in position.
Reinstallation of Plates:
You should not have any reason to remove the plates from the Trap. If however you do, merely
slot the plates back into the ribs so that the Control Box is on the upper-side of the Top Plate and
the Fan is on the under-side of the Bottom Plate. There is an arrow on each plate that points to
the back of the Trap (i.e. the half that does not contain the Timer) when the plates have been
properly installed.
Connection of Wires:
You should not have any reason to remove any of the electrical connections except as part of the
battery disposal process (see Page 20 - Disposal of Timer section). All electrical connections are
by push-in pin connectors. Provided these are not forced it is not possible to plug any connector
into the wrong connector hole.
There are three connector holes on the underside of the Top Plate. The two smaller twopin
connector holes are for the Fan and Heater Cables. These two connections are interchangeable
so it doesnt matter which of these two connector holes the Fan and Heater are plugged into. The
third connection on the underside of the Top Plate is a three-pin hole and fits only the U.V. Bulb
Connection Cable. The connection holes into the Control Box on the upperside of the Top Plate
are all different sizes and fit the remaining cables.
Re-assembly of Trap:
With the Top and Bottom Plates in place replace the "timer-side" or top half of the Trap ensuring
that each plate slots into the locating ribs. The 12 screw holes should now be aligned for replacement
of the screws and nuts. Hold the nuts into the pre-formed hexagonal holes and carefully screw
in the screws.
(NOTE: Do not overtighten the screws. This could cause the nuts to rotate and damage the pre-
formed hexagonal fittings in the plastic housing.)