Mega Lite Piccolo Blinder 120 User Manual - page 6
Display Menu
6
The control board on the fixture is your interface to access and control
all the functions on the unit. Its digital display gives you a code view of
the options and functions. The following will explain each function and
its options.
DMX Address
Press Enter to select the DMX start channel. Use the up/down keys (001 to 512) , Press
Enter to confirm the setting. Press ESC to return to Main Menu.
(Note: Display must be on Main Menu for fixture to operate on DMX Mode)
Main Menu / Configure mode
Mode
Down
Up
Enter
CONTROL BOARD
Mega Lite
Piccolo 120
Address
001
(CH6)
DMX On
Main Menu
>Config Mode
System Info
Led All On
Press Enter to select the DMX Channel mode of operation. Use the up/down
keys to select Channel mode from
Mode 1 Dimmer
Mode 2 Dimmer, Strobe
Mode 5 Dimmer, Dimmer Fine, Strobe, Macro, Dim Curve
Press Enter to confirm the setting. Press ESC to return to Main Menu.
Config Mode / Channel Mode
Config menu
>Channel Mode
Keep Screen On
Keep DMX Data
This function allows you to enter the Configure section of the menu. Press Enter
to continue or ESC to return to Main Menu
Press Enter to establish your display screen settings. Use the up/down keys to
Select enable or disable the screen. Press Enter to confirm the setting. Press
ESC to return to Main Menu.
(Note: In disable mode the screen will turn off after 30 seconds of no use.)
Config Mode / Keep Screen On
Config menu
Channel Mode
Keep Screen On
Keep DMX Data
Press Enter to establish your loss of DMX signal settings. Use the up/down
keys to Select enable or disable. Press Enter to confirm the setting. Press ESC
to return to Main Menu.
(Note: In disable mode the led will turn off after loss of DMX Signal. In enable
mode it will hold last setting after loss of DMX signal.)
Config Mode / Keep DMX Data
Config menu
Channel Mode
Keep Screen On
>Keep DMX Data