Megalarm MEGA 250 Operation manual - page 4
I. VALET MODE:
(System in Disarm or Valet mode)
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your
transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm
function and remote start function are bypassed, however the remote panic feature and remote door locks
will remain operational. To use the valet mode, the system must first be disarmed either by using you
remote transmitter, or by operating the Manual override sequence.
Enter Valet Mode:
1. From the disarmed condition, turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds until the LED turns on. The LED wills remain on as long as the
system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'on'.
2. Push and hold valet switch for 2 seconds, The LED wills turns off indicate the system are exiting the
valet mode.
J. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency.
1. Press and hold the
button for 3 second. The alarm will immediately sound.
2. During panic mode, the normal function of this transmitter button will be suspended. The
and
buttons can be used to lock and unlock the doors (if the option is installed), however once the
button
is pressed, the vehicle’s starter disable device, (where installed) will be enable allowing the vehicle to
start.
3. To stop the alarm, press and hold
or
button on the transmitter again for 3 seconds. Also if any
transmitter buttons other than
or
button is pressed and released, the panic mode will be turned
off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
K. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm with a unique feature which will turn on your vehicle dome light as following:
1. Upon disarming, the interior lights will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.
L. IGNITION CONTROL DOOR LOCKS.
(See Alarm Feature
II – 2
Programming).
If the vehicles door locks have been interfaced to the security system, the system will automatically lock
the vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is
turned “OFF”.
M. CHANNEL 3 (TRUNK RELEASE) OUTPUT
Press and hold
button on transmitter for two seconds to remote control the trunk release or other
electric devices.
N. CHANNEL 4 OUTPUT
(See Alarm Feature I – 4/5 Programming)
Press
and
buttons at the same time to remote control the optional electrical device. The device
will 'on' when the button(s) press continuously, and 'off' when the button(s) released.
O. CAR LOCATOR
Press
button twice with 3 seconds to active car locator function. The horn will chirp 6 times. The
parking light will flash 12 times, for you to easily locate your car.
MEGA 250 OPERATE
4