Megalarm MEGA 474 Installation And Operation Manual

Manual is about: DELUXE 3-CHANNEL ALARM SYSTEM

Summary of MEGA 474

  • Page 1

    03282008 mega 474 deluxe 3-channel alarm system installation and operation manual megatronix chatsworth, ca u.S.A. Mega 470/474; vs 465/474l 1.

  • Page 2

    03282008 mega 470/474; vs 465/474l 2.

  • Page 3

    03282008 wiring diagram h1: main 5 pin white harness h3: 6 pin white mini connector black antenna wire led indicator valet switch h7/1 blue wire: (-) 200ma unlock pulse h7/3 green wire: (-) 200ma lock pulse h7 3 pin white h2 4 pin orange h5 2 pin blue h6 2 pin white h4 black wire dual zone shock sen...

  • Page 4

    03282008 wiring keep wiring away from moving engine parts, exhaust pipes, and high-tension cable. To prevent fraying, tape wires that pass through holes on the firewall. Watch out for sharp edges that may damage wires and cause short circuit. Caution: do not connect the wiring harness to the control...

  • Page 5

    03282008 d). When the extend wires are needed, they must be exactly same gauge as the cut wire. Connect the cut wire from the key switch to the red wire (pin #30) of the relay, and connect the starter wire to the white wire (pin #87a) of the relay. E). Connect the orange wire from the control module...

  • Page 6

    03282008 +12v master door lock switch x x splice splice cut the existing lock wire to door lock motor to slave door lock switches cut the existing unlock wire 3 pin plug to alarm 5-wire alternating door lock 30 86 87a 85 87 30 86 87a 85 87 +12v green wire blue wire vacuum operated centrol locking gr...

  • Page 7

    03282008 programming a. Programming transmitter: note: this unit will only retain the last 4 remote transmitters programmed. If the transmitter memory is full, the security system will start deleting transmitters from memory in chronological order. 1. Turn the ignition switch ‘off/on’ 3 times and st...

  • Page 8

    03282008 exit : turn ignition to 'on' position, or leave it for 15 seconds. A 3 long chirps to confirm exit. Password pin code setup: 1. Turn the ignition switch ‘on/off’ 3 times and stay in the off position. 2. Push the valet switch 8 times and hold it in on the 8 th push until four chirps with a l...

  • Page 9

    03282008 4 chirps disarm / intrusion 12 flashes car locator 6 chirps car locator e. Alarm operating condition: siren parking light led doors starter disable pager 1. Arming 1 chirp 1 flash slow flash locking on 2. Disarming 2 or 4 chirps 2 or 3 flashes off or fast flash unlocking off 3. Trigger alar...

  • Page 10

    03282008 2. Within 5 seconds, enter your chosen 10ths digit by press and release the valet switch. (when finished above procedures, system's siren stop alarming, parking light stop flashing, but the vehicle cannot be start and drive away.) 3. Turn the ignition switch “off” position. [4] chirps form ...

  • Page 11

    03282008 mega 470/474; vs 465/474l 11.

  • Page 12

    03282008 mega 470/474; vs 465/474l 12.