Summary of AXIS 250
Page 3
Check that the unit has not been damaged during transport protection against fire 1. Maintain a minimum of 1 foot distance from any type of flame. 3. Replace fuse only with the specified type and rating. 4. Do not install the unit to close to a heat source. 5. Make sure cable are properly secured aw...
Page 4: Specifications
4 part numbers fixture lamp flight case 1030 - axis 250 lnsk250/2 9051-dual flight case mechanical specifications fixture packaged for shipping size: 16.75”l x 16”w x 20.5”h weight: 52 lbs size: 20”l x 19.25”w x 22.25”h weight: 61.60 lbs pan: 530° tilt: 280° dmx connectors: 3-pin xlr connectors refl...
Page 5
Color gobo dmx channels channel function channel function channel function 1 pan 7 color wheel 13 prism rotation 2 tilt 8 gobo wheel 14 focus 3 pan fine 9 gobo rotation 4 tilt fine 10 shutter 5 pan/tilt speed 11 dimmer 6 control 12 prism 1: open 2: red 3: yellow 4: purple 5: light green 6: orange 7:...
Page 6: Main Power Connection
6 main power connection caution! 1. Do not connect fixture to a dimmer system. 2. This unit must be earthed. (electronically grounded) 3. Replace fuse only with the specified type and rating. The occupation of the connection-cable is as follows: cable (usa) cable (eu) pin international brown brown b...
Page 7: Lamp Replacement
7 lamp replacement caution! 1. Disconnect power before you begging. 2. Allow 15min for the unit and lamp to cool. 3. Do not touch lamps glass envelope with your fingers. If this happens clean with alco- hol / to remove oils. To insert the lamp msd 250/2, hsd250. Use a phillips screw- driver to unscr...
Page 8
8 axis 250 dmx profile dmx channel function description value 1 pan pan 0-255 2 tilt tilt 0-255 3 pan fine pan fine 0-255 4 tilt fine tilt fine 0-255 pan/tilt speed (from fast to slow) 0 5 speed max speed 1-249 blackout during movement 250-252 6 reset reset 200-209 open 0-13 red 13-25 yellow 26-38 p...
Page 9: Main Control Menu
9 main control menu the control board on the fixture base is your interface to access and control all the functions on the unit. Its digital display gives you a code view of the options and functions. The following will explain each function and its options. Mode mo de enter ent er down do wn up up ...
Page 10: Cleaning And Maintenance
Cleaning and maintenance installation maintenance: the operator has to make sure that the unit is operating safely and has the installations and electron- ics checked by an expert every 2 years. The following points have to be considered during the inspection: 1) all screws used for installing the d...
Page 11
Mega-lite 5718 kenwick st san antonio, tx 78238 ph 210-684-2600 fax 210-855-6279 www.Mega-lite.Com / info@mega-lite.Com.