1. DL manuals
  2. Megamaster
  3. Grill
  4. Blaze 600 Black
  5. User Manual

Megamaster Blaze 600 Black User Manual

Summary of Blaze 600 Black

  • Page 1

    Lpgsasa permit number ( 1185-11/2-rsa-12a ) www.Megamaster.Co.Za manufactured in china· distributed by mega group · po box 15, woodlands, 0027, south africa· tel: +27(0)12 802 1515 d f warning for outdoor use only . Warning this grill is not intended to be installed in or on recreational vehicles an...

  • Page 2: Table Of Contents

    Table of contents operating instructions braai ignition instructions care and maintenance trouble shooting warranty information 30 30-31 32 33 34 safety instructions package contents list hardware contents exploded view part list assembly instructions gas hook –up installer final check list leak tes...

  • Page 3: Safety Instructions

    1. Never leave the braai unattended while it is on. 2. Never operate this appliance within 10 ft (3 m) of any structure, combustible material or other lp gas cylinder. 3. Never operate this appliance within 25 ft (7.5 m) of any flammable substance. 4. Do not fill cooking vessel beyond maximum fill l...

  • Page 4: Safety Instructions

    Braai installation check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the south african national standard 1539, storage and handling of liquefied petroleum gases, correct lp gas cylinder use lp gas br...

  • Page 5: Safety Instructions

    Lp-gas supply system • if this information is not followed exactly, a fire resulting in death or serious injury could occur. • a 9kg lp gas cylinder of approximately 30cm in diameter by 52cm high is the maximum size lp gas cylinder to use. • the safety feature prevents the cylinder from being overfi...

  • Page 6: Safety Instructions

    Proper placement and clearance of braai • never use your gas braai in a garage, porch, shed, or any other enclosed area. Your gas braai is to be used outdoors only. Do not install this unit in combustible enclosures. The minimum clearance from sides and back of unit to combustible construction is 61...

  • Page 7: Safety Instructions

    Do not heat unopened food containers on the braai. A build-up of pressure may cause the containers to burst. Ensure that your hand is covered with protective gear when opening the braai lid. Never lean over an open braai. When lighting a burner, pay close attention to what you are doing. Make certai...

  • Page 8: Package Contents List

    D. Cart leg rear,right package contents list 8 a. Cart leg front,left--- 1pc r.Firebox assembly--- 1pc b. Cart leg rear,left --- 1pc c. Cart leg front,right -- -1pc --- 1pc e. Swivel caster --- 2pcs f. Swivel caster with brake---2pcs g. Side panel---3pcs h. Side panel right,top --1pc i. Bottom panel...

  • Page 9: Package Contents List

    Package contents list 9 s.Side burner,right --- 1pc t. Side burner end cap,right --- 1pc u. Side shelf---1pc v. Side shelf end cap,left ---1pc w. Triangle braket for side shelf ---2pcs x.Side tube burner --- 1pc y.Control knob ---1pc z.Pulse igniter module 1pc aa.Grease tray---1pc af.Flame tamer---6...

  • Page 10: Hardware Contents

    Ref# description specification quantity a truss head screw 1/4-20x3/5’’ 14pcs b truss head screw 5/32-32x2/5’’ 18pcs c flat washer 1/4” 6pcs d flat washer 5/32” 4pcs 10 hardware contents.

  • Page 11: Exploded View

    2 2 1 4 5 6 3 7 7 10 8 9 11 11 12 13 14 20 19 18 17 15 16 21 22 23 24 25 26 27 28 29 30 34 33 32 31 35 36 37 39 40 42 33 41 43 44 45 46 30 35 47 48 49 49 50 49 51 52 53 54 55 58 59 57 56 61 60 62 63 64 65 66 67 68 69 38 11 exploded view.

  • Page 12: Part List

    No part (description) warranty coverage (year) qty no part (description) warranty coverage (year) qty 1 main lid 1 1 23 main manifold 1 1 2 main lid screw 1 2 24 side burner flex gas line 1 1 3 main lid handle 1 1 25 side burner gas valve 1 1 4 temperature gauge 1 1 26 side manifold 1 1 5 temperatur...

  • Page 13: Part List

    No part (description) warranty coverage (year) qty no part (description) warranty coverage (year) qty 45 pulse igniter module 1 1 58 cart leg front,right 1 1 46 side burner igniter wire 1 1 59 cart leg rear,right 1 1 47 triangle bracket,right 1 1 60 swivel caster with brake 1 2 48 triangle bracket,l...

  • Page 14: Assembly Instructions

    C) loosen, but do not remove the screws that are pre- assembled on the cart leg rear leg right(d) and cart leg front right (c). Attach cart leg rear right(d) and cart leg front right (c) to side panel (g)by aligning the holes on the side panel(g).Tighten the screws that were loosened above.As shown ...

  • Page 15: Assembly Instructions

    15 assembly instructions fig. 4 fig. 5 fig. 6 d) loosen, but do not remove the screws that are pre- assembled on the cart leg rear leg right(d) and cart leg front right (c). Attach cart leg rear right(d) and cart leg front right (c) to side panel,top (h)by aligning the holes on the side panel,top(h)...

  • Page 16: Assembly Instructions

    C) loosen but do not remove the screws that were pre-assembled on the cart leg front left(a) and cart leg front right(c), attach cart leg front left (a) and cart leg front right (c) to cart frame (n), by aligning the holes on the cart frame.Then tighten the screws that are loosed before.As shown in ...

  • Page 17: Assembly Instructions

    17 assembly instructions fig. 10 fig. 11 fig. 12 5. Door assembly a) loosen but do not remove the screws that were pre-assembled on the bottom panel (i),attach door iron piece(k), tighten the screws that were loosened above.As .As shown in fig.10. B) unscrew the screws that were pre-assembled on the...

  • Page 18: Assembly Instructions

    6. Firebox assembly a) move the firebox asssembly (r) from the carton and carefully place onto the grill cart.Lid handle will face front and be above front panel.As shown in fig.13. Note:the firebox assembly is heavy and will require two or more people to lift and position onto grill cart.Failure to...

  • Page 19: Assembly Instructions

    19 assembly instructions fig. 16 b) using 2 pcs truss head screw (b) to connect side shelf end cap,left (v) and side shelf (u) .As shown in fig.16. C) using 2 pcs truss head screw (b) to connect triangle braket for side shelf (v) and side shelf (u).As shown in fig.17. D) loosen but do not remove the...

  • Page 20: Assembly Instructions

    20 assembly instructions fig. 19 fig. 20 fig. 21 e) using 3pcs truss head screw (a) and 3 pcs flat washer (c) to connect left side shelf and firebox assembly (r),using 1pcs truss head screw (b) to connect side shelf front panel,left and main control panel. As shown in fig.19. 8. Right side burner as...

  • Page 21: Assembly Instructions

    21 assembly instructions fig. 22 fig. 23 c) using 2 pcs truss head screw (b) to connect side burnder end cap,right(t) and side burner,right (s)).As shown in fig.22. D) loosen but do not remove the 2 pcs screws that were pre-assembled on the firebox assembly (r) right side,attached right side burner ...

  • Page 22: Assembly Instructions

    X 22 assembly instructions fig. 25 fig. 26 f) loosen the screws which pre-assembled on the side burner gas valve then align the screws to the valve with the large side of the holes on the bezel,fix with vertical gourd holes,then tighten the screws.As shown in fig. 25. G) insert control knob (y) into...

  • Page 23: Assembly Instructions

    Side burner lgniter wire side burner 3mm 23 assembly instructions fig. 29 9. Pulse igniter module and battery assembly a) remove igniter battery cap and lock washer from igniter.Insert pulse igniter module (z)throuth from back of side burner control panel,secure lock washer from front of side burner...

  • Page 24: Assembly Instructions

    24 assembly instructions fig. 31 fig. 32 10. Grease tary and grease box installation a) attached grease cup support bracket a(ab) to grease tray(aa) by using 2pcs truss head screw(b) and 2 pcs flat washers (d).As shown in fig.31.As shown in fig.31. B) attached grease cup support bracket b(ac) to gre...

  • Page 25: Assembly Instructions

    25 assembly instructions fig. 34 fig. 35 d） install the grease tray (aa) from the rear of the grill by sliding the tray on the glides at the rear of the grill until centered under the cooking area.As shown in fig. 34. E) install the grease box (ae) under the grease tray(aa).As shown in fig.35. 11. C...

  • Page 26: Assembly Instructions

    26 assembly instructions fig. 37 fig. 38 b） place the cooking grids (ag) into the grill. As shown in fig.37. C） insert legs of warming rack (ah) into the holes on the top of firebox side panels.Place side burnder cooking grid (ai) into the side burner.As shown in fig.38. 1. Connecting regulator to t...

  • Page 27: Gas Hook-Up

    Never connect an unregulated gas supply line to the appliance. Use the regulator/hose assembly supplied. This is a lp gas configured braai. Do not attempt to use a natural gas supply unless the braai has been reconfigured for natural gas use. Total gas consumption (per hour) of this stainless steel ...

  • Page 28: Leak Test

    Minimum clearance from the sides and back of the unit to combustible constructions is, 61cm from the sides and 61cm from the back. All internal packaging removed. Knobs turn freely. Burners are tight and sitting properly on orifices. Pressure regulator connected and set. Gas connections to braai usi...

  • Page 29: Leak Test

    Caution place dust cap on cylinder valve outlet when the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leaking of lp gas. The gas must be turned off at the supply cylinder wh...

  • Page 30: Operating Instructions

    Using the braai each main burner is rated at 12,000 btu/hr. The main braai burners encompass the entire cooking area and are side ported to minimize blockage from falling grease and debris. The igniter knobs are located on the lower center portion of the valve panel. Each rotary igniter is labeled o...

  • Page 31

    1. Open lid during lighting. 2. Make sure all the knobs are in the “off” position, and then turn the liquid propane cylinder valve “on” by slowly turning counterclockwise. 3. Push and turn main burner control knob to ignite/high or ignite/on, at the same time, press and hold electronic ignition butt...

  • Page 32: Care And Maintenance

    Stainless steel there are many different stainless steel cleaners available. Always use the mildest cleaning procedure first, scrubbing in the direction of the grain. Do not use steel wool as it will scratch the surface. Specks of grease can gather on the surfaces of the stainless steel and bake on ...

  • Page 33: Trouble Shooting

    Spider and insect warning checking and cleaning burner/ venturi tubes for insects and insect nests. A clogged tube can lead to a fire beneath the braai. Spiders and small insects occasionally spin webs or make nests in the braai burner tubes during transit and warehousing. These webs can lead to gas...

  • Page 34: Trouble Shooting

    Problem solution when attempting to light my braai, it will not light immediately. Make sure you have a spark while you are trying to ignite the burner if there is no spark: -ensure that the wire is connected to the electrode assembly. -clean wire (s) and / or electrode with rubbing alcohol and a cl...

  • Page 35: Warranty Information

    This braai has a one (1) year limited warranty. The warranty period is valid from the date of purchase. Please retain your proof of purchase. This is subject to correct assembly, use, storage and regular maintenance of the product. Please refer to page 13 and 14 of this manual for list of replacemen...

  • Page 36: Warning

    For outdoor use only warning read and follow all safety, assembly, and use & care instructions in this guide before assembling and cooking with this grill. Failure to follow all instructions in this use & care guide may lead to fire or explosion, which could result in property damage,personal injury...