Megapix DWC-MF10M28T Quick Start Manual
Quick Start Guide
DWC-MF10M28T, DWC-MF10M36TIR,
DWC-MF10M8TIR
MEGApix® 720P
TM
1MP Camera
Ver. 1.0 / 2015.03
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
1
1
2
3
4
5
Before installing your camera:
1. The mounting surface must bear five times the weight of your camera.
2. Do not let the cables get caught in improper places or the electric line cover to be damaged.
This may cause a breakdown or fire.
Reset to the Factory Default
Press the reset button for 5 seconds to
return the setup to the factory default.
Warning:
Pressing the ‘Reset’ button will result in
the lose of all setting data. If needed,
make a note for further installation.
Detach the dome cover from bottom
case using the wrench provided.
When closing the dome back on the
camera, align the camera’s dome with the
sticker at the bottom of the camera for proper
sealing and protection.
Product & Accessories
Part Name
Disassemble the Camera
Installation
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
To disconnect power from the mains, pull out the mains cord plug. When install the product, ensure that the plug is easily
accessible.
Camera
Cables
Screw &
Plastic Anchor-3pcs
Manual CD
Quick Manual
Template Sheet
for installing by Plate
Template Sheet
for installing by Bolt & Nut
Mount Bolt & Nut
Mount Plate
Torx Wrench
Plate Hook
Mount Plate
Lens
Reset Button
Bottom Case
Gimbal
Bezel
Tilt Stopper Screw
Reset Button
Template Sheet
DC Power Cable
RJ-45 Cable
Dome Cover
Sticker
20150316
TEL: (866) 446-3595
www.Digital-Watchdog.com / technicalsupport@dwcc.tv
Technical Support Hours: Monday-Friday 9:00AM to 8:00PM EST
Detach the camera’s cover dome from the camera’s
module by unscrewing the cover dome screws using the
L-Wrench. See ‘Disassemble the Camera’ for more
information.
Use the camera or mounting template to mark and drill
the necessary holes in the wall or ceiling.
Pull wires through and make connections.
Using three (3) included screws, mount and secure the
camera to the wall or ceiling.
Secure the camera’s cover dome onto the camera base
to complete the installation.
To adjust the camera’s orientation:
1. Loosen the tilt stopper screw at the base of the
camera’s Gimbal by rotating it counter clock-wise.
2. Move the camera to the desired angle.
3. Secure the camera’s lens position by screwing the tilt
stopper screw clock-wise.
To use the LAN water protector case:
1. Insert the network cable into (a), the camera’s
network port.
2. Connect (b) to the camera’s network port by rotating it
clock-wise until tight.
3. Attach part (c) to the case’s body, securing tightly by
rotating it clock-wise.
a
b
c