Megasat Seaman 37 User Manual And Installation Instructions - page 11
System Components
Antenna unit
The elegant plastic housing will protecting the antenna
against outside weather conditions. Under the housing there
is a 37 cm (45 or 60 cm) high-performance antenna. The new
technology of 0-90° elevation enables optimal reception ac-
ross Europe.
Control unit
The control unit is used for satellite selection and control. It
is connected between the antenna and the set-top box and
supplied the antenna with electricity.
Open box and remove the control unit, cables and packing material. Lift the antenna
straight up out of the box. Never place the system upside down!
ENGLISH
ENGLISH
04
05
Warning:
Seaman 45 and 60 additionally has an auto skew feature that automatically
adjusts the angle of polarization of the LNB and a GPS receiver for fast and
accurate positioning.
Warning: transport lock
Then remove with the „LOCK“
marked screw inside the antenna.
Seaman
Connection
Install the control unit and the set-top box is not inside the vehicle in the region of an
airbag. Maintain a careful installation of the cable in order to avoid short circuits. Pay
attention also to existing cables.
Connect the antenna as shown in the illustration below:
12~24 V DC 5 A
Ant
enna
Receiv
er
or with the optional
power supply
230 V AC / 12 V DC 5A
Television
Receiver
RED
BLACK
( - )
(+)