MEGATRONIX RS 110 Manual - page 2
RS110
ADD-ON REMOTE CAR STARTER
For Vehicles Equipped With Automatic Transmission
For Fuel Injection Gas And Diesel Engines
Remote start: To activate the remote start, press the
auxiliary channel button on the transmitter of your existing
alarm or keyless entry system. The parking lights will flash
once, indicating it received the start signal. When the
engine starts running, the parking lights will flash 2 quick
flashes every 3 seconds for its 10-minute runtime (or 20
minute runtime if pre-programmed). If the engine fails to
start the first time, after 10 seconds, the remote start unit
will make two attempts to restart the engine.
When the engine is running in remote start mode, first turn
the ignition key to the ‘ON’ position, then press the brake
pedal to disengage the remote start and now you can
proceed with normal driving. Note: pressing the brake
pedal before turning the ignition key to the ‘ON’ position
will cause the remote start to disengage and stop engine.
To remotely stop engine running in remote start mode,
press the auxiliary channel button on the transmitter of
your existing alarm or keyless entry system.
Leave the vehicle running during stopover: During a
stopover, if you wish to leave your vehicle running for 10
minutes (or 20 minutes if pre-programmed) without the
ignition key, press the aux. channel button on the
transmitter for 3 seconds while the engine is running with
the ignition key ‘ON’, the parking lights will flash once.
Turn the ignition key to ‘OFF’ position, remove the key,
and exit the vehicle without pressing the brake pedal. The
remote start system will keep the engine running for 10
minutes (or 20 minutes if pre-programmed).
Automatic engine start feature: To start the engine
automatically every 3 hours five times, press the aux.
channel button on the transmitter for 3 seconds while the
engine is running with the ignition key ‘ON’, the parking
lights will flash once. Within 7 seconds remove the ignition
key and press the brake pedal.
This feature will be deactivated when the remote start is
activated again or by turning the ignition key to the ‘ON’
position.
Note:
-When the hood is opened in remote start mode, the
engine will stop OR when the hood is open, it will not
allow the remote start unit to start the engine (use pin
switch and connect to trigger input (–) (blue wire).
-Do not operate the remote start in a closed garage.
Yellow / Black Wire – (-) 200ma Ignition 2 Output
This wire provides a 200mA (-) ground output that
becomes active before the remote start unit initialize, and
remains grounded while running.
Some newer vehicles use a 2nd ignition wire which is
required to start and keep the vehicle’s engine running. If
this is the case, wire an IGN 2 relay (not supplied) as
shown below:
Do not connect any vehicle circuits together, they are
isolated for a resaon.
Yel/Blk Wire
87a
Ignition 2 Wire From
Ignition Key Switch
+ 12 V Constant
Fused 25A Capable
30
85
86
87
Green / White Wire – (-) 200ma Starter 2 Output
This wire provides a 200mA (-) ground output that
becomes active before the remote start unit initialize, and
remains grounded while running.