Megxon M1 Quick Start Manual - page 7
02
03
103mm+-1
1
4
0
m
m
+
1
-2
103mm+-1
02
03
02
03
12
13
TV Connection
1.Video-out:
(1)Turn on the player and TV set.
(2)Go to SETUP mode of the player and set up the Video
type. (NTSC or PAL)
(3)Connect AV Out port of the player to Video input ports
of the TV set with the supplied Video Cable.
(4)Enter Video/Audio/Photo mode of the player and select
the file you want to show on screen for TV viewing.
2.TV/VCD/DVD player recoding:
(1)Turn on the player and TV set/VCD/DVD player.
(2)Make sure the TV program or VCD/DVD you want to record
is ready.
(3)Connect AV IN port of the player to Video output ports of
TV set/VCD/DVD player with the supplied Video Cable.
(4)Enter the AV IN mode and press to start recording.
Please refer to AV IN mode.
Connecting the Player to a PictBridge-supported Printer
If the printer you have supports the interface of PictBridge,
then you can have your camera connected with the printer by
the supplied USB cable to have the stored images print out
directly.
1.Have both of the player and the printer powered on.
2.Go to the SETUP mode of the player and select the USB
settings on PRINTER.
3.Use the supplied USB cable to connect the player to the
PictBridge-supported printer as shown above.
Printer Connection (PictBridge settings)