Megxon TX5000 Manual - page 5
1
6
5
m
m
+
-2
122mm+-2
10
11
Switch On or Off the Camera
Loading the Batteries
Using an AC Adapter
Inserting an SD Card
Getting Ready
Getting Ready
Batteries may lose power if kept inside the camera for a long time without
using. Please remove the batteries while the camera is not in use.
Do not use manganese batteries since they cannot supply sufficient power to
support the camera's operation.
Batteries may not work normally under 0
.
It's normal that the temperature of the camera body goes up after being in use
for a long period.
Long time use is suggested to use an AC adapter.
In order to avoid any damage caused by bad quality AC adapters, please
contact the original company, selling you the camera.
1. Check if the camera is switch off .
2. Make sure the AC adapter is 3.3V/2.0A.
3. Connect the AC adapter connector with the DC In socket on the camera.
4. Connect the adapter itself with the power outlet
5. Switch on the camera.
1. Switch off the camera.
2. Open the Battery / Memory Card Cover.
3. Insert the SD card into the card slot and press it down until a click sound
happens
4. Close the Battery / Memory Card Cover.
Slide the "POWER" switch sideways and
hold it awhile to switch on the camera.
Repeat the action above to switch off the
camera.
1. Check if the camera is switched off.
2. Slide the Battery / Memory Card Cover out to open it.
3. Load 2 x AA batteries into the battery chamber, following the
polarity indications.
4. Close the Battery / Memory Card Cover.
Note
The below symbols are the indication of the battery status on the TFT LCD
Monitor.
( ):Battery power is full.
( ):Battery power is half drained. Have new batteries ready.
( ):Battery power is drained. Replace the batteries you are using now.
Note
Please refer to the suggested battery shown below to ensure the normal
operation of the camera.
Brand Type
Duracell(Ultra) Alkaline
Note