MEI MEI 710E-3DD Installation Instructions Manual
1
•
Unstable installation causes vibration and
noise of refrigerator.
•
Wooden floor or carpet can be discolored
under the refrigerator.
•
Doors look hanged down due to the twist
of refrigerator unless it is leveled.
•
More than 10 cm from 3 sides (left, right
and back) is good enough for ventilation.
•
Insufficient space causes the noise of
vibration, weakening of refrigerating
power and the waste of electricity.
•
Direct sun lays, side heat of stove and gas
range can weaken the refrigerating power.
•
Avoid location by a sink or where moisture
and water can cause rust and corrosion.
•
Avoid location where moisture can cause
electrical problems.
•
Use hard board or plank on the
concrete/cement floor.
1. Installation Instructions
Where the floor is solid and level
Where ventilation is good
Where there is little or no heat, moisture
Suitable Installation Place
Grounding is necessary
where
Grounding by using
grounding wire
Grounding by using
short-circuit breaker
Grounding is not necessary
You should not connect the
ground wire to
■
Grounding terminal is the green one connected to the power cord in the back of refrigerator.
The electrical plug must be accessible without moving the set.
Bury copper plate to whitch grounding wire is connected 25 cm deep in the ground.
Short-circuit breaker is a must where the floor is always wet, for example, fish shop,
restaurant kitchen etc.
in case of using side-grounded outlet.
water pipe, gas pipe, telephone line,
lightening-rod.
There can be explosion or fire.
Grounding wire
Side
Grounded
outlet
Grounding
Correct usage of Refrigerator
Installation Process
water can splash easily ;
bathroom etc.
there is much moisture ;
basement etc.
any wet and/or watery
places.
Plug in the refrigerator
right after installation.
Set the both
compartments’
temperature to “3” to
perform preparatory run
for 2 or 3 hours.
When the inside is cold
enough, put the foods in.
* See page
for
details.
* When the surrounding
temperature is hot in
midsummer, do not
open and shut the doors
too often after
installation.
2
Attatch the height adjustable legs to their holes in the
left and right bottom of refrigerator.
Adjust the height by turning the legs until they touch the floor.
•
Let the right adjustable leg touch the floor firmly, while the
left, smoothly.