Meicheng SP-5018M User Manual - Sp-5018M
5
SP-5018M
1.
+5V DC
: Power jack for 5V4A DC
2.
HDMI In1
: HDMI Input1 for connecting to a HDMI source here
3.
HDMI In2
: HDMI Input2 for connecting to a HDMI source here
4.
EDID
: DIP Switch (see the definition in the next section)
5.
Out1 – Out8
: RJ-45 Output 1-8 to link to the HDTV through HDMI over CAT5 receiver CV-715 or CV-715s
DIP Switch
Switch Position
OFF
[]
ON
[]
Pin#1
Input HDMI source #1
Input HDMI source #2
Pin#2
Source 1 use default EDID
Source 1 use learned EDID
1
Pin#3
Source 2 use default EDID
Source 2 use learned EDID
2
Pin#4
7.1 Channel
3
2 Channel
Pin#5
HDMI 1.2 output
HDMI 1.3 output
Pin#6
HDMI mode output
DVI mode output
1
1
1
1
Set pin#2-ON
[] firstly and then connect the HDMI Input to HDMI display through HDMI cable. Waiting
for 20 seconds, the learning procedure will be accomplished. When update the EDID content with
another display, you must set pin#2-OFF[] and repeat this procedure again.
2
2
2
2
Set pin#3-ON
[] firstly and then connect the HDMI Input to HDMI display through HDMI cable. Waiting
for 20 seconds, the learning procedure will be accomplished. When update the EDID content with
another display, you must set pin 3 off and repeat this procedure again
3
3
3
3
While 7.1 channel option is selected for the HDMI signal with only stereo audio, the HDMI
display may show video without audio. In this case, please set audio to stereo audio.
Panel Descriptions
DIP Switch
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
5
5
5
5