1. DL manuals
  2. Meijer
  3. Indoor Fireplace
  4. HYWN-23
  5. Owner's Manual

Meijer HYWN-23 Owner's Manual

Summary of HYWN-23

  • Page 1

    Electric fireplace mantel owners manual model hywn-23 only use this fireplace mantel and insert as described in this manual. Any other use is not recommended by the manufacturer, and may cause fire, electric shock, or other personal injury. Warning! Read and understand this entire owner’s manual, in...

  • Page 2: Warning

    2 important safety information! Warning  always keep electric cords, home furnishings, drapes, clothing, papers, or other combustibles at least 3 feet (0.9m) away from the front of this insert, and away from the bottom, sides, and rear of this insert.  do not place the insert near a bed because ob...

  • Page 3: Warning

    3 warning  risk of electric shock! Do not open! No user-serviceable parts inside!  always disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace.  always store this insert in a dry location. Never use the fireplace if it ...

  • Page 4: Preparation

    4 preparation a complete electric fireplace consists of two parts; the mantle and the electric fireplace insert. Each is packed in a separate carton. Always use the electric insert with the matching mantle. Remove all parts from the carton and place them on a clean, soft, dry surface. Check the part...

  • Page 5: Assembly

    5 assembly step 1. Thread wood screw (j) through bottom connector on left side panel (b) and into hole in hearth (a). Secure with phillips screwdriver. Do not over-tighten. Repeat for right side panel (c). Step 2. Thread screws (j) through connectors in right side panel (c) and into right front pane...

  • Page 6

    6 step 3. From behind, thread screws (j) through holes in header (f) and into holes in left and right front panels (d/e). Secure with phillips screwdriver. Do not over-tighten. Step 4. Set mantel (g) on top of hearth assembly. Thread screws (j) through holes in side panels (b/c) and header (f) and i...

  • Page 7

    7 ant-tip safety kit installation a. Secure one bracket (h2) to an inside rear surface of the mantel with two 5/8” screws (h3). Tighten the screws with a phillips screwdriver. Do not over-tighten. B. Position the mantel in the desired location and mark the wall where the second bracket will be mount...

  • Page 8: Limited Warranty

    8 limited warranty this warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use and proper care, remain so for one year from the date of purchase. Missing or initially defective parts will be ...