Modeltech 123752 Instructions For Final Assembly - page 7
7
Global stocks a complete line of replacement parts for your Modeltech Fun Fly 90S ARF. Listed below are the replacement
parts that are available along with their respective part numbers for easy ordering convenience. We suggest ordering
directly from your local dealer. If your dealer does not stock Modeltech products, you can order directly from us at the
address shown below:
Global Services
18480 Bandilier Circle
Fountain Valley CA 92708
Phone: (714) 963-0329 Fax: (714) 964-6236
SECTION 5: REPLACEMENT PARTS
On the Web
http://globalservices.globalhobby.com
SECTION 6: A NOTE ABOUT COVERING
The covering material used on the Modeltech Fun Fly 90S ARF is real iron-on, heat-shrink covering material, not
cheap "shelf paper." Because of this, it is possible with heat and humidity changes that the covering on your airplane
may wrinkle or sag. This trait is inherent in all types of heat-shrink material. To remove any wrinkles that might be
visible you will need to purchase, or borrow from a fellow modeler, a heat iron. If you need to purchase one, the
Global Heat Sealing Iron # 360900 is recommended.
Follow this simple procedure to remove the wrinkles:
❑ Plug in and turn on the sealing iron to the medium-high temperature setting. Allow the sealing iron to heat up for
approximately 5 - 7 minutes.
❑ After the sealing iron has reached temperature, lightly apply the sealing iron to the wrinkled section of the covering.
Move the sealing iron slowly over the wrinkled section until the covering tightens and the wrinkles disappear.
✦
✦
✦
✦
✦IMPORTANT✦
✦
✦
✦
✦ You will notice that the color of the covering will darken when it is heated. When the covering cools
back down, it will return to its normal color.
☞
If the color layer smears from any of the seams the temperature of the sealing iron is too hot. Turn the temperature dial
down and wait about 5 minutes for the sealing iron to adjust to the lower temperature. You can remove any excess color
streaks using a paper towel soaked with a small quantity of Acetone.
We do not suggest storing your airplane in an extremely hot environment (like the back of your car in direct
sunlight) for any length of time. The extreme heat could cause the covering material to wrinkle or sag and possibly
damage the fragile components of the radio system.
PRO TIP
Fun Fly 90S ARF - Complete ................................. 123752
Instruction Manual ................................................. 120023
Wing Set ................................................................ 120024
Fuselage Set .......................................................... 120025
Stabilizer Set .......................................................... 120026
Engine Mount Set w/Hardware .............................. 120027
Aluminum Landing Gear Strut ............................... 120028
Hardware Set .......................................................... 120029
Decal Set ................................................................ 120030
Fuel Tank Assembly ................................................ 170823
Tail Wheel Assembly ............................................... 170825