Modern Fan Co Altus Installation Instructions - page 3
(12)
Install rotor using the four rotor screws
from step
(11)
. Be sure screw tabs on rotor
are properly aligned with correct holes on
motor.
(13)
Install bottom cap by rotating in the
clockwise direction, or if using the optional
light, proceed to step
(14)
.
(16)
Your fan is reversible for summer and winter
operation. The reverse switch is located on the top
of the fan body. The LEFT position is for summer
and the RIGHT position is for winter.
reverse switch
(17)
The rotor and motor of your fan have been dynamically balanced at the
factory. In addition, the blades have been matched to the nearest gram to ensure
a well balanced ceiling fan. Furthermore, a blade balancing kit has been included
with your fan. Please refer to the instructions packaged with the balancing kit
should your fan require additional balancing.
(15)
Install control as described in the control installation instructions.
(a)
Remove the three
socket plate screws
and set aside for
step
(c)
.
(b)
Run socket wires
through socket plate,
connect to wire leads
from fan, and screw
socket to socket plate
with socket screws.
(c)
Reinstall socket
plate with screws from
step
(a)
.
(d)
Install standard
(A-19) lamp (75 watt
max.). Lamp not
included.
(e)
Align channels in
globe with fittings on
fan and rotate
clockwise until
securely in place.
(14)
To install optional light kit, begin by
identifying all parts. Then follow steps
(a)
through
(e)
:
globe
socket
socket screws