1. DL manuals
  2. Modern Flames
  3. Indoor Fireplace
  4. AMBIANCE LINEAR 100
  5. Safety Information And Operations Manual

Modern Flames AMBIANCE LINEAR 100 Safety Information And Operations Manual

Other manuals for AMBIANCE LINEAR 100: Safety Information And Operations Manual
Manual is about: fireplace

Summary of AMBIANCE LINEAR 100

  • Page 1

    Read these instructions completely before beginning installa- tion. Failure to follow them could cause a heater malfunction resulting in serious injury and/or property damage. Warning: all electric heaters have hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or ...

  • Page 2: Table Of Contents

    2 table of contents important instructions........................2 listing approvals...............................3 product dimensions..........................4 box contents………..........................5 unpacking and testing…..................5 locating fireplace.............................6 wh...

  • Page 3: Important Instructions

    3 mechanical adjustment, or repair. 6. Do not use outdoors. 7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never lo- cate heater where it may fall into a bathtub or other water container. 8. Do not run cord under carpeting. Do not cover cord with thr...

  • Page 4: Product Dimensions

    4 product dimensions al clx 40 40” w x 25.5” h x 3.48” d al clx 60 60” w x 25.5” h x 3.48” d al clx 100 100” w x 25.5” h x 3.48” d.

  • Page 5: Box Contents

    5 box contents unpacking and testing this heater is for use on 120 volts. The cord has a plug as shown at a. An adapter as shown at c is available for connecting three-blade grounding-type plugs to two-slot re- ceptacles. The green grounding lug extending from the adapter must be connected to a perm...

  • Page 6: Locating Fireplace

    6 locating fireplace caution: do not locate in a moist room such as a bathroom or laundry room. Caution: wear gloves and safety glasses for protection during installation and mainte- nance. This electric fireplace can be installed framed in to a wall or simply hung on the wall. Install at least 1 f0...

  • Page 7

    7 recessed installation: 1. Prepare frame opening according to chart. Frame opening is slightly larger than the fire unit. 2. Attach l-metal brackets to the fire unit with the provided small washer head screws. 3. Secure fire unit to the finished framed opening with the provided large washer head sc...

  • Page 8

    8 wall-hung installation: 1. Hang the mounting bracket with the included large washer head screws and wall anchors. Wall anchors should be used at the highest outside corners. Be certain that at least two screws are driven in to solid backing. Use the chart to see proper distance between the screws ...

  • Page 9: Operation

    9 operation on the bottom of the unit is a main power switch. Switch this on to begin using the fireplace. Directly below the flame, on the right hand side are 3 small led status lights and 3 buttons. When all indicator lights are off, pressing on any button will only show the status. Once the indic...

  • Page 10

    10

  • Page 11

    11.

  • Page 12: Frequently Asked Questions

    12 frequently asked questions q. How do you program the remote control? A. The remote comes pre-programmed. No programming is necessary. Q. What distance can the remote be used from the fireplace? A. Optimal distance for the remote control is within 10 yards. Q. Can you turn on the fireplace via the...

  • Page 13: Troubleshooting

    13 troubleshooting problem possible cause corrective action nothing comes on (touch screen, etc.) a. Fireplace is not plugged in to an electrical outlet a. Check plug b. Breaker tripped or outlet has no power b. Reset breaker, test outlet for power c. Power switch is not in the “on” position (bottom...

  • Page 14

    14 problem possible cause corrective action fireplace turns off and will not turn back on a. Fireplace has overheated and safety disc has snapped or circuit breaker has tripped a. Turn off major power switch and waiting 5 minutes to turn it back on or reset circuit breaker can operate fireplace func...

  • Page 15: Notes

    15 notes cleaning and maintenance there is very little maintenance involved with your electric fireplace. Please fol- low the few points below:  on a semi-annual basis unplug the machine from it’s power source, remove the glass face of the fireplace and dust the fire unit with a dry cloth. Be care-...

  • Page 16

    16 © 2011 www.Modernflames.Com please dispose of properly..