ModWright Instruments LS 100 Owner's Manual - Input Selection:
6
HT/BP input is meant for integrating 2CH into a Multi-Channel or Home Theater system.
When used in this mode, home theater preamp or processor is connected to HT/BP inputs and
signal is output straight to 2CH main stereo outs. This allows direct connection to front L/R
channel amp(s) with no sonic impact from LS 100 preamp.
Input Selection:
Inputs may be selected via front panel or remote control.
Depressing Input button on remote control toggles through inputs in order.
Opt. (optional upgrade) input is also selected this same way, and if upgrade is not installed, there
will simply be no signal when Opt. input is selected.
At power up, balance control is out of circuit, allowing for the cleanest signal path. Balance
control may be activated via front panel or remote control. Once activated, left knob on front
panel allows for signal balance adjustment from L to R.
Home Theater Bypass (HT/BP) input can ONLY be activated via front panel controls.
This product is fitted with an IEC input, for use with detachable power cords. Unless otherwise
specified, unit is designed for use with 120V-60Hz AC power. Main fuse is located inside unit,
accessible by removing top cover
(ONLY DO SO WHEN UNIT IS POWERED OFF AND DISCONNECTED FROM ALL
SOURCES OF POWER).
Only replace fuse with 1.5A Fast-Blo type.
Ground:
You should
ALWAYS
use a grounded AC cord with this product. The chassis is always
connected to earth ground if unit is fitted with proper grounded AC power cord.