Moen 2200 Series Installation Instructions

MT659C

MODELS 2200, 2400 & 72200 SERIES

INSTALLATION INSTRUCTIONS

THESE INSTRUCTIONS MUST BE

LEFT WITH HOMEOWNER

TUB AND SHOWER VALVES

All models have 4 port castings.  Stops are optional on all models.  All models are also available for 1/2 inch I.P.S. pipes

or 1/2 inch copper sweat connections to copper water tubing.  The 2400 series include built in pushbutton diverter.

Measurements

CAUTION:

Always turn water off before disassembling the valve.  Open valve handle to

alleviate water pressure to insure that complete water shut-off has been

accomplished.

Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place.  The

cartridge and retainer clip were properly installed and tested before leaving the factory.  Although it is unlikely, it is

nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not be

properly installed.  This should be carefully checked at time of rough-in and trim-out.  If the retainer clip is not properly

installed, water pressure could force the cartridge out of the casting.  Personal injury or water damage to the

premises could result.

UP

These are shown in the drawings.  The depth

measurement is critical.  Use the front face of

the plaster ground as a reference point for the

finished wall position, including tile (2-1/16"

[51mm]).   The center line of the supply and

discharge piping should be a maximum of 2-3/16"

(56mm) and a minimum of 1-7/16" (37mm) behind

the finished wall surface.

UP

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

➤

HANDLE

COVER

O-RING

HANDLE

SCREW

HANDLE

KNOB

ESCUTCHEON

WASHER

PLASTER

GROUND

1-1/4"

(32mm)

2-1/16"

(52mm)

CAUTION:

USE 1/2" IRON

PIPE SIZE

MINIMUM.  DO

NOT USE 1/2"

TUBING, EXCEPT

WHEN SLIP FIT

SPOUT IS USED.

COMBINATION

MODELS 32"

(813mm)

SHOWER

45"

(1143mm)

48"

(1219mm)

6'6"

(1981mm)

SUPPLY 1/2" I.P.S. OR

COPPER SWEAT

2400 MODEL SERIES

PUSH  BUTTON DIVERTER

MODEL ILLUSTRATED

ALL DIMENSIONS NOMINAL

➤

WALL LINE

FLOOR

UP

®

CLIP

EAR

IMPORTANT: SEE FLUSHING

INSTRUCTIONS PAGE 2