Moen 7300 Installation Instructions

7300, 8700 SERIES

INSTALLATION INSTRUCTIONS

THESE INSTRUCTIONS MUST BE

LEFT WITH HOMEOWNER

KITCHEN DECK FAUCETS

Single-Handle - for Eight-Inch Centers

MT170

CAUTION:

CLIP

EAR

Equipped with Flow-Rator® Aerator or Swing-N-Spray Aerator

Always turn water off before disassembling the valve.  Open valve

handle to relieve water pressure and insure that complete water shut-

off has been accomplished.

Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place.  The

cartridge and retainer clip were properly installed and tested before leaving the factory.  Although it is unlikely,

it is nevertheless possible that through the handling of the valve by any number of persons the retainer clip

may not be properly installed.  This should be carefully checked at time of rough-in and trim-out.  If the retainer

clip is not properly installed, water pressure could force the cartridge out of the casting.  Personal injury or water

damage to the premises could result.

Complies with ASME A112.18.1M and CSA B125

Measurements

"FLOW-RATOR"

AERATOR

9" (229mm)

SPOUT

7-1/2"  (191mm) 

NOMINAL

OPEN POSITION

1/2" STRAIGHT

PIPE THREAD

MOUNTING

NUT/WASHER

TAILPIECE NUT

FOR 8" (203mm) CENTERS

5-3/8" (137mm)

NOMINAL

(9" SPOUT)

7-1/8" (181mm)

NOMINAL

(12" SPOUT)

DECK ESCUTCHEON

10" (254mm) X 2" (51mm) WIDE

(DECK GASKET IS ONLY

USED WITH DECORATOR MODELS)

2-1/8"

(54mm)

DECK

GASKET

®